Simple RS 232 Level Converter

Posted on Feb 5, 2014

When you need connect your Microcontroller Project to COM port in PC you need RS 232 converter. There are many chip to solve the problem like MAX232, DS275 etc. But if you need simple and chep for RS 232 converter, i though this circuit will be usefull for you. The design made by Wichit Sirichote. `A circuit diagram shown above was used two small

Simple RS 232 Level Converter
Click here to download the full size of the above Circuit.

signal transistor, NPN and PNP transistors. Dash line separate transmitter and receiver circuit. For those who need only transmitter circuit can use above circuit (and GND (5) signal ). Technically the RS232C is -3V to -12V for logic `1` and +3V to +12V for logic `0`. The transmitter circuit uses PNP transistor, BC557. While in mark state the TxD signal is logic `1`, Q1 turns off. TxD (pin3) then provides -9V (depends on what converter chip being used for COM1, say) to RxD (pin2). For space state, TxD control signal then becomes logic `0`, which turns on Q1, the approx. +5V is then fed to RxD (pin2). With this method, while sending data has being made, TxD (pin3) must stable at -9V, say"

Leave Comment

characters left:

New Circuits



Popular Circuits

Two-Door Annunciator
Hi-fi Audio Amplifier Circuit Design and implementation
Light sensor using Op Amp
12 V Florescent lamp driver circuit
Magic Wand Conjuring Trick.s
mk120 light barrier 12v dc power supply
Stereo Tube Amplifier
40W fluorescent lamp electronic ballast circuit
Output current boost circuit PGA202 OPA633