Simple Serial AVR Programmer


Posted on Feb 5, 2014

This simple AVR Programmer able to transfer hex programs to most ATMEL AVR microcontrollers. It is more reliable than most other simple AVR programmers available out there and can be built in very short amount of time. This Programmer support the AVR microcontroller ATmega103, ATmega161, ATmega163, ATmega 323, ATmega128, ATmega8, ATmega16, ATmega6


Simple Serial AVR Programmer
Click here to download the full size of the above Circuit.

4, ATmega32, ATmega162, ATmega169, ATmega8515, ATmega8535, ATmega44, ATmega88, ATmega168, ATmega164, ATmega324, ATmega644, ATmega640, ATmega1280, ATmega1281, ATmega2560, ATmega2561, AT90can32, AT90can64, AT90can128, ATtiny12, ATtiny15, ATtiny26, ATtiny2313, ATtiny13, ATtiny25, ATtiny45, ATtiny85, ATtiny261, ATtiny461, and ATtiny861. you can also use it directly in the main circuit by adding a pin to plug this cable programmers, so you do not need to remove the chip while it is to program. The PCB connector has been created to match the ATmega8 AVR microcontroller, 28-DIP, but you can build a PCB socket for each other AVR microcontroller out there. This AVR programmer software is compatible with popular PonyProg showing the status bar the progress of programming. This minimum system schematics using crystal 4 Mhz, you can use other crystal frequency depend on your fuse bit setting, please be careful when setting fuse bit and security lock. if you wrong. you can`t recovery your chips and your chips will damage. expected, you have High voltage programmer.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Inductance adapter for frequency meter
    Light Chaser I
    rear wheel tachometer
    audio tone control with 2 transistor
    Battery Charging
    Peak Detector Circuit
    Crystal Sine Wave Oscillators
    Guitar Stompbox & Effects Projects
    Introduction
    Meter load economizer circuit diagram



    Top