Solar Cell Voltage Regulator


Posted on Feb 6, 2014

This device is designed to be a simple, inexpensive comparator`, intended for use in a solar cell power supply setup where a quick too low` or just right` voltage indicator is needed. The circuit consists only of one 5V regulator, two transistors, two LEDs, five resistors, two capacitors, and one small battery. Although a 4-V battery is indicated,


Solar Cell Voltage Regulator
Click here to download the full size of the above Circuit.

4. 5 V (3 alkalines in series) or 3. 6 V (3 NiCd cells in series) will also work. The specifications of voltage regulator IC1 are mainly determined by the size and number of the solar cells and the current pull of the equipment connected to the output. Here the low-drop 4805 is suggested but other regulators may work equally well as long as you observe the output voltage of the solar cells. Transistors T1 and T2 are complementary types i. e. one each of the pnp and npn variety. Although the ubiquitous BC557B (pnp) and BC547B (npn) are indicated, any small-signal equivalents out of the junk box will probably do. The values of voltage dividers R1/R6 and R3/R4 may need to be adjusted according to the type of transistor and its gain, or according to the desired voltage thresholds. Using the resistor values shown in the schematic, LED D2 turns on fully when the voltage is just above 5 volts. LED D1 turns on when the voltage drops below 4. 2 volts or so. Between those two thresholds, there is a sort of no man`s land where both LEDs are on dimly. A buzzer or other warning device could be connected across the terminals of LED D1 to give a more substantial warning if the voltage drops below operating limits. The current consumption of the circuit is about 20 mA at 5 V, and it decreases with the voltage supplied by the solar cells.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Slow Servo
    Daylight alarm with 555
    Guitar and bass tuner
    Child-Proof Reset Switch
    40M Cw Transmitter Circuit
    DC fan control circuit for power amplifier Schematic Diagram
    audio stereo channel selector circuit
    Liquid-Crystal Display (LCD) Tester
    High-intensity LED Warning Flasher
    led interfacing with tms320f2812 tyro
    Improving the MICOR Receiver for 435-450 MHz
    High-voltage isolation switch operation display circuit
    Using ASCII keyboard code development system



    Top