Step Up PSU for LCD


Posted on Feb 6, 2014

To start old Optrex DMC50264N LCD module you need to get +24V LCD bias voltage Where to get it if you have only low voltage 3 5V As LCD module drains very low current, it is possible to build very small DC/DC converter. There are lots of chips designed for this. I used MC34063, as I already had few of them in some old trash boards. The schem


Step Up PSU for LCD
Click here to download the full size of the above Circuit.

atics are typical, used from datasheet. As the current is very low, it is possible to use very small SMD inductance. I didn`t find very small, so I used quite big- about 1cm tall




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Selectable sensitivity Preamplifier
    Triangle-to-sine converters
    USB Printer Share Switch Circuit Project
    Thermometer with PIC Microcontroller
    midi to dmx arduino control shield
    555 tlc555 relay driver circuit
    Schematics USB Sound Card with PCM2702 PCB
    Infrared Remote Control Tester
    12v 10 minute Off-Delay timer
    Electronics and Home Automation
    Micropower thermometer



    Top