Strobe Flash Light Circuits


Posted on Feb 6, 2014

This circuit uses12V DC instead od mains AC. This is very good idea if you don`t want to mess with direct mains voltage connected circuit or you want to run the stroboscope from batteries. Flash Slave Trigger : Flash slaves are used when you need to supplement1-flash unit with1-or several more. This slave trigger simply triggers those other units.


Strobe Flash Light Circuits
Click here to download the full size of the above Circuit.

It does this by "seeing" the first flash (using a phototransistor) and triggering the other flashes a few microseconds later. The sensitivity of the circuit is adjustable to compensate for ambient light or dimmer than usual master flashes. Hacking the Kodak Max Single Flash Camera Into a Self Repeating Strobe : this approach is recommended mainly for home brewing a strobe that is powered by a single1. 5 volt battery. If you can use a higher supply voltage, there are better ways to do this. brightness of the LED at all frequencies. This is accomplished by duty-cycle and pulse width control. It is useful for measuring the speed of motors. It can easily be calibrated using a watch so you don`t need a frequency counter.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Flash triggering circuit
    Precision thermocouple signal amplifier
    Signal-injector
    Open-Loop Peak Detector Circuit
    Nokia 7610 MMC Corrupt Problem Picture Help
    Noise-producing sound effects using NE555
    voltage to frequency converter
    linearize single arm wheatstone bridge output
    Linear Amp Project HF VHF UHF Amplifier
    mini light
    HT7070A Voltage Detector
    Switching the constant current source consisting of the application circuit W723
    Simple design with a constant K-type high-frequency low-pass LC filter



    Top