Twin-T Audio Oscillator circuit


Posted on Feb 7, 2014

The output of this circuit should be fed into a high-impedance load, say >100K, remembering that the impedance of C4 is around 3K. A PNP transistor can also be used, with the necessary changes to the supply voltage. An op-amp can also be used, connected as follows: Op-Amp Transistor Output Collector Inverting Input Base Non-Inverting Input Emitter


Twin-T Audio Oscillator circuit
Click here to download the full size of the above Circuit.

R1 = R2 R3 = 0.1 x R1 C2 = C3 C1 = 2 x C2 R4 = 3K3 (approx) C4 = 50nF (approx) Q1 = any NPN audio amplifier. e.g. BC108, etc Vcc is not critical, 6 to 12Vshould work fine. Higher or lower voltages may also work OK.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Simple Spectrum Analyzer Adaptor For Scopes Circuit
    Timer Blox
    noise LM386 audio amplifier not amplifying
    Stroboscope Uses White LEDs
    DESKTOP 386SX PC AS DAQ (Data AQuisitor)
    ELECTRONIC COMBINATION LOCK
    Range precision voltmeter circuit
    Photoreceiving circuit diagram LM307 amplifier configuration
    PQS1 series magnetic disk control panning control circuit



    Top