Uplifter Switches


Posted on Feb 5, 2014

Just ran a +12V switched wire back to the camera wiring and connected it to the same place that the reverse lights connect. That way, either the reverse lights or my switch can enable the camera. The important thing here is the use of diodes! These are used to isolate the two circuits, to keep the voltage from one of the `enable circuits` from back-feeding into the other. For instance, without a diode, if I would


Uplifter Switches
Click here to download the full size of the above Circuit.

turn the switch on the dash to see the camera, my reverse lights would come on.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Schmitt trigger with LM741 op-amp
    Sequential ac flasher
    Remote ring extender switch
    Digital-touch-on-off-switch
    Digital Automatic Level Control (Alc) Circuit
    Bipolar Stepper Motor Driver Circuit
    Homemade exposure unit
    tl072 car subwoofer filter circuit
    Wireless mains voltage tester
    200 solar charged remote control lawn mower
    PIR motion detector circuit electronic project
    Video monitor adapter enhances oscilloscope
    I2S isolator
    Dynamic mic preamplifier circuit
    STK4040x1 made HI-FI amplifier circuit



    Top