avr programmer how to make

  
Inside:
Repository
This simple AVR Programmer will allow you to transfer hex programs to most ATMEL AVR microcontrollers without sacrificing your budget and time. It is more reliable than most other simple AVR programmers available out there and can be built in very short amount of time. AVR programmer consists of in-circuit serial programmer (dongle) and small pcb
avr programmer how to make - schematic

with a DIP socket that you can fit your microcontroller and program it quickly. You may also use this programmer as a stand alone in-circuit serial programmer that can be used to conveniently program AVR microcontrollers without removing them from the target circuit. Entire AVR programmer has been build with using common parts and fits in the case of the serial connector. The socket pcb has been created to fit a 28-DIP AVR ATmega8 microcontroller, but you can build a socket pcb for any other AVR microcontroller out there. This AVR programmer is compatible with a popular PonyProg software that shows you a status bar of the programming progress. Socket PCB consists of the PCB, 28-DIP socket, 4MHz crystal resonator, or crystal with two 22pF decoupling capacitors, and two header connectors. Two-PIN connector supplies +5V voltage to the AVR microcontroller, and 6-PIN ICSP connects to AVR Programmer dongle. Supplying microcontroller with external +5V voltage as opposed to taking it directly from computer`s serial connection port ensures that the chip is receiving exactly +5V voltage and provides very reliable error free programming. To be able to send hex file from your computer to AVR microcontroller you will need to download and install PonyProg2000. After the installation, the first thing you will need to do is configure PonyProg to work with our AVR Programmer. To do this go to "Setup" menu and select "Interface Setup". The...



Leave Comment

characters left:

New Circuits

.