dual power supply circuit


Posted on Feb 5, 2014

The circuit a series of Dual Power Supply, where the symmetrical ± 15V supply for linear circuits. The same principle applies to supplies of non-symmetrical, such as 5. 0 V and-12V regulators for applications such as registers. To ensure start up LM340 over full temperature range of the load sink current worst case 1. 0a germanium power diode  D1


dual power supply circuit
Click here to download the full size of the above Circuit.

was added to the circuit. Since the forward voltage drop of the germanium diode D1 is less than that of the silicon substrate diode of the LM340 the external diode will take any fault current and allow the LM340 to start up even into a negative voltage load. D1 and silicon diode D2 also protect the regulator outputs from in advertent shorts between outputs and to ground. For shorts between outputs the voltage difference between either input and the opposite regulator output should not exceed the maximum rating of the device. Here is a schematic drawing:




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

AM reciever with MK484
Floodlamp power control
pH Sensors LMP91200 Schematic Diagram
Questions about colpitts oscillator design
Servo Tester Using A 4538
ATMEGA32 8-bit AVR Microcontroller with 32K Bytes In-System Programmable Flash
Intelligent fire alarm telephone alarm circuit - finger circuit
Automatic level control circuit diagram of six



Top