fast voltage driven current source


Posted on Feb 4, 2014

The current source in the diagram, which react very fast to changes in the input signal, may be used, for instance, in certain measurements. Differential amplifier IC1 ensures that the potential across R2 is equal to the input voltage: Iout =Uin/R2. The bandwidth, B, is given by B=R2 f /RL, where f=80 MHz, and the load impedance RL‰¥ R2 (both in


fast voltage driven current source
Click here to download the full size of the above Circuit.

ohms). The input is terminated into R1 to give the usual 50 impedance required by measuring instruments. At the same time, this resistor sets the d. c. operating point. If the link to the driving signal source is short and d. c. coupled, R1 may be omitted. The peak voltage between pins 1 and 2 of the IC is limited to 2. 1 V to prevent too large a current at the output. Therefore, the peak output current is 2. 1/100=21 mA.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    3 LED - 1 Cell battery tester
    Nicad-batterv-protection-circuit
    Demultiplexer
    15V And 5V Car Battery Supply
    Stereo Circuit Schematic of The ADAU1592 Audio Power Amplifier
    CD4013 Push Button CMOS Toggle Flip Flop
    shortwave radio receiver circuit project
    Two way Simple Very Small Telephone Exchange
    relay triac
    Parallel Port Stepper Motor Driver With Discrete Components
    2SC2922 and 2SA1216 or 2SC3264 and 2SA1295 power amplifier circuit
    Resistive neutral leakage protection circuit



    Top