float charger for nimh cells


Posted on Feb 5, 2014

Although not a new device, the LM317 is still a high-performance regulator. Its output voltage is essentially immune to fluctuations in load, supply voltage and temperature and this makes it ideal as the central element in a float charger for NiMH cells. Float charging has the advantage of keeping the cells fully charged and ready to use without t


float charger for nimh cells
Click here to download the full size of the above Circuit.

he potential damage of long-term trickle charging or the cost of low-discharge cells. This works because NiMH cells do not have the memory problems associated with Ni-cads. The circuit is based on a conventional LM317 regulator. Resistors R2 & R3 and trimpot VR1 set the maximum output voltage to between 1. 3V and 1. 4V per cell. VR1 should be adjusted for a value of 1. 35V per cell at the regulator output. Resistor R2 has been fixed at 240O. The formula for the voltage output is: Vout = 1. 25*(1 + (R3 + VR1)/R2). Diode D1 protects the circuit against reverse polarity of the power supply and protects the LM317 should the power be disconnected while it is still connected to a charged battery pack. Resistor RCL and transistor Q1 limit the maximum current in the event of a short circuit or the connection of a severely discharged battery pack. LED2 provides an indication of voltage input to the charger. LED1 and the 680O resistor provide the same function for the charger output and also provide a minimum load for the regulator when the battery pack is nearing full charge. This is necessary to keep the regulator output from drifting up and damaging the batteries. The circuit uses an external DC plugpack and is suitable for four NiMH cells rated at 2. 5Ah. Table 1 gives alternative values for 1-10 batteries in series at peak charge currents of between 200mA to 600mA. If you are using the specified plug-pack and the TO-220 packaged...




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Voltage regulator for projection lamp
    Timing-threshold-and-load-driver
    Reset Protection For Computers
    Electronic Slot Machine Circuit
    audio Can I use a PNP Transistor with an Electret Microphone to get an non-inverting output for my Arduino
    solar charger circuit by lm317
    usb only sc1
    walter duo
    Boost Led Driver With 1:3000 Dimming Ratio And Excellent Current Regulation
    How to build Modular Class A Buffer preamplifier
    Electromechanical relay logic
    Simple ADS-B Receiver
    Simulator Test Tools Speed Circuit Design
    Ultrasonic remote control dimmer light circuit
    LM4911 different power circuit conduction time recommended



    Top