fm wireless microphone circuit

Posted on Feb 5, 2014

This FM wireless microphone is easy to build and has a large benefit of transmission (about 300 meters, while outdoor). Regardless of its small component count and 3V operating voltage that will easily penetrate the excess of some floors of an apartment development. It can be adjusted everywhere, while in the FM band (87-108MHz) and its transmissi

fm wireless microphone circuit
Click here to download the full size of the above Circuit.

ons can be picked up at any ordinary FM receiver. The coil (L1) should be about 3 mm in diameter, with five rounds of 0. 61 mm copper wire. You are able Tx frequency range by simply adjusting the distance between the coils. The antenna should be half or quarter of an extended wave (100 MHz 150 cm or seventy-five centimeters). FM wireless microphone circuit The audio amplifier stage (T1) is a conventional common emitter amplifier. The 47nF capacitor isolates the microphone from the base voltage to the transistor and only allows AC signals to pass. The LC tank circuit T2 occurs, the feedback capacitor C5 and the parallel LC circuit L1, C4. The coupling capacitor (C6) directs the signal to your amplifier RF (T3). FM Wireless Microphone calibration circuit: Location of the transmitter 10 feet of a FM radio. Place the radio in a 89 to 90 MHz Spread the coil in the coil L1 frequency tuning also sought.

Leave Comment

characters left:

Related Circuits

  • New Circuits



    Popular Circuits

    2x 2,500W RMS stereo amplifier
    wein bridge sine wave oscillator lm101
    rgb color sensor on arduino
    digital led voltmeter circuit
    6 channel audio mixer
    telephone call voice changer
    Schematics power supply switching PCB
    HEAT SENSOR image
    8-Channel Air Sampler and Biodetection