li ion white led driver by


Posted on Feb 7, 2014

In addition to providing an accurate input current limit, the LT1618 can also be used to provide a regulated output current for current-source applications. White LED drivers are one such application for which the LT1618 is ideally suited. With an input voltage range of 1. 6V to 18V, the LT1618 can provide LED drive from a variety of input sources,


li ion white led driver by
Click here to download the full size of the above Circuit.

including two or more alkaline cells, or one or more Li-Ion cells. The circuit in Figure 7 is capable of driving six white LEDs from a single Li-Ion cell. LED brightness can be adjusted using a pulse width modulated (PWM) signal, as shown, or by using a DC voltage to drive the IADJ pin directly, without the R3/C3 lowpass filter. If brightness control is not needed, simply tie the IADJ pin toground. Typical output voltage with the LEDs shown is around 22V, and the R1, R2 output divider sets the maximum output voltage to around 26V to protect the LT1618 if the LEDs are disconnected. The LT1618G ‚¬ s constant-current loop regulates 50mV across the 2. 49W sense resistor, setting the LED current to 20mA.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Simple strobe circuit
batteries Li-Poly battery charger with protection Schematic review
usb pow
max2659 gpsgnss low noise amplifier
DCF77 Preamplifier
IMPROVED REGENERATIVE SW RECEIVER



Top