mobile incoming call indicator


Posted on Feb 7, 2014

This circuit can be used to escape from the nuisance of mobile phone rings when you are at home. This circuit will give a visual indication if placed near a mobile phone even if the ringer is deactivated. When a call is coming to the mobile phone, the transmitter inside it becomes activated. The frequency of the transmitter is around 900MHz. The co


mobile incoming call indicator
Click here to download the full size of the above Circuit.

il L1 picks up these oscillations by induction and feds it to the base of Q1. This makes the transistor Q1 activated. Since the Collector of Q1 is connected to the pin 2 of IC1 (NE555), the IC1 is triggered to make the LED connected at its output pin (pin 3) to blink. The blinking of the LED is the indication of incoming call. The coil L1 can be made by making 150 turns of 36 SWG enameled copper wire on a 5mm dia plastic former. Or you can purchase a 10 uH coil from shop if available.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    Panner Waveform Generator
    Receiver If Amplifier
    Telephone Line Tester Circuit
    Simple High Quality Preamp For Hi-Fi
    DIY mobile phone jammer Schematic Diagram
    Phase Shift Oscillator
    Sound Blaster Microphone Preamplifier
    Isolated 1-Hz Clock
    Higher Input Or Output for L200 Voltage Regulator
    Transistorized Auditory Gimmick
    OP amplifier using FET input type long analog timing circuit



    Top