pierce xtal oscillator circuit


Posted on Feb 7, 2014

This circuit is conventional Pierce  type oscillator that uses a JFET. The circuit uses fundamental mode crystals. It has decent performance and reliability if we use a low noise JFET. This is the figure of the circuit. The feedback is controlled by the C1 Capacitance from drain to ground. Adjusting the frequency can be done by adjusting a shunt


pierce xtal oscillator circuit
Click here to download the full size of the above Circuit.

capacitance C2 across the crystal. The crystal works in parallel mode. This circuit is suitable where some crystals should be switched in and out to select the frequency, as there`s no tuning required.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

80x32 LED matrix display
Piezoelectric-fan-based-temperature-controller
Phone Message Flasher
3v low battery voltage flasher
Dual level liquid sensor circuit design using CA3410 op amp
Brovin Kacher Tesla
Antenna Tuning Unit
Electronic games schematic circuit
Automatic washing machine motor driver schematic



Top