power supply schematic

Posted on Feb 7, 2014

An electronic recitification circuit. The use of large, heavy and expensive electrolytic capacitors is avoided, being replaced by an active transistor in this gyrator circuit. To avoid excess ripple output on a power supply feeding a heavy load, usually a large value capacitor is chosen following the rectifier. In this circuit, C1`s value is only

power supply schematic
Click here to download the full size of the above Circuit.

a 470uF. The gyrator circuit works on the principle that the value of input capacitance at the base-emitter terminals of a transitor is effectively multiplied by the static forward current gain, HFE of the transistor. In this circuit C2, a 100uF capacitor is effectively magnified at the ouput ( Vreg ). If you assume a dc current gain, HFE of 50 for the 2N3055 power transistor, then the effective value of the smoothing capacitor would be 50x this value; or be the same as using a 5000uF capacitor without the power transistor. The graph below shows the output voltage and current through the load :- The load draws nearly 400mA. With the output directly from the rectifier there is about 5v pk-pk ripple in the output. Using the output at the emitter of the transistor things are much better. The circuit will take a few hundred milliseconds for the output voltage to stabilize and reach maximum value. The advantages are that a smaller, less costly reservoir capacitor can be used with this circuit to give a high quality

Leave Comment

characters left:

Related Circuits

  • New Circuits



    Popular Circuits

    Arduino FM radio receiver shield
    Design a esthetic and energy-conserving acousto-optic controlled lighting lamp of corridor
    Tube Preamplifier 5687 Led Biased
    Modulated Light Barrier
    Original 2N2/40 Schematic Diagrams
    SR63 holiday lights ASIC
    Adjustable from 3 to 9V 100mA power supply circuit
    Complementary symmetry FET operating principle
    Clock synchronization oscillator circuit