radio remote control


Posted on Feb 4, 2014

Circuit Here is a circuit of a remote control unit which makes use of the radio frequency signals to control various electrical appliances. This remote control unit has 4 channels which can be easily extended to 12. This circuit differs from similar circuits in view of its simplicity and a totally different concept of generating the control signal


radio remote control
Click here to download the full size of the above Circuit.

s. Usually remote control circuits make use of infrared light to transmit control signals. Their use is thus limited to a very confined area and line-of-sight. However, this circuit makes use of radio frequency to transmit the control signals and hence it can be used for control from almost anywhere in the house. Here we make use of DTMF (dual-tone multi frequency) signals (used in telephones to dial the digits) as the control codes. The DTMF tones are used for frequency modulation of the carrier. At the receiver unit, these frequency modulated signals are intercepted to obtain DTMF tones at the speaker terminals. This DTMF signal is connected to a DTMF-to-BCD converter whose BCD output is used to switch-on and switch-off various electrical applicances (4 in this case). The remote control transmitter consists of DTMF generator and an FM transmitter circuit. For generating the DTMF frequencies, a dedicated IC UM91214B (which is used as a dialler IC in telephone instruments) is used here. This IC requires 3 volts for its operation. This is provided by a simple zener diode voltage regulator which converts 9 volts into 3 volts for use by this IC. For its time base, it requires a quartz crystal of 3. 58 MHz which is easily available from electronic component shops. Pins 1 and 2 are used as chip select and DTMF mode select pins respectively. When the row and column pins (12 and 15) are shorted to each other, DTMF tones...




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Phase Control Circuit
Square wave generator III
Switched-mode-motor-speed-controller
Ac-circuit-breaker
Voltage-Tuned Vhf Oscillator
Communication between a USB/serial device and an AVR (atmega/Arduino) microcontroller
vackar vfo oscillator
Simple portable Audio power amplifier circuit using LM386 IC
Abbey
LM1035 36 application circuit
555 monostable circuit diagram of a low power consumption



Top