rf detector electronic project circuit design using 2n2222 transistors


Posted on Feb 5, 2014

This electronic rf detector electronic project is designed using common transistors and other few common electronic parts. This rf detector responds to RF signals bellow the standard broadcast band to well over 500 MHz and provides an visual, and audible indication when the signal is received. By adjusting the bias of D2 with the R2 potentiomete


rf detector electronic project circuit design using 2n2222 transistors
Click here to download the full size of the above Circuit.

r the circuit can detect low power or strong signals. The circuit can be powered using a simple 9 volts battery or any other 9 volts DC power supply circuit. If the rf detector is not enough sensitive you can connect a good wideband RF amp between the antenna and the detector diode. Keep diode and capacitor (C1) leads short to minimize stray inductance. The used transistors can be : 2N3906, 2N2907 or other PNP high gain transistor for Q2 and PN2222A, 2N3904 or other NPN high gain transistor for Q1.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    3 LED - 1 Cell battery tester
    Hf Broadband Antenna Preamp Circuit
    Optoisolator And Optocoupler Interface circuits
    Simple Fire alarm circuit using LDR
    Sine Wave Generation Techniques
    PLL FM Transmitter Circuit
    Night Light Saver
    Push Off Push On
    ACC FC-1 Remote Base Interface circuit
    An AVR microcontroller based Ethernet device



    Top