ultrasonic electrostatic transducer for


Posted on Feb 4, 2014

This is a complete design circuit for a complete ultrasonic transceiver used in a variety of pulse/echo-ranging applications. Here`s the figure of the circuit; In this circuit, the LM1812 transmits a burst of oscillations with transducer X1. Then, using the same X1, listens for a return echo. If an echo of sufficient amplitude is received, the LM1


ultrasonic electrostatic transducer for
Click here to download the full size of the above Circuit.

812 detector produces a pulse (pin 16) of about the same width as the original burst. The closer the reflecting object, the earlier the return echo. Using the values and parts shown, the circuit has a range of about 4 inches to 30 feet. L6 resonates at 50 to 60 kHz, with the 500-pF capacitance of X1. L1 is tuned to this frequency by watching for maximum echo sensitivity with a scope at pin 1. [Circuit diagram source: National Semiconductor Application Notes and Seekic. com]




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Sound amplitude meter
Strobe Alarm
Simple Audio-Frequency Vco
Precision Light Alarm With Hysteresis Circuit
Differential Current Sensing Inside H Bridge
Attiny2313 based LAN cable tester
timer Simple Metronome Circuit w/ Linear Pot Control
laser command circuit
STI5211 Low-cost HDTV Satellite Set-top Box Decoder For Microsoft VC-1 H.264 And MPEG-2
Features and Power Control Circuit
forester: window regulator to all the way down to install it
Power MOSFET Bridge Rectifier
Electronic Transformer Coupled Oscillators



Top