water alarm schematic


Posted on Feb 6, 2014

The LM1830 fluid detector IC from National Semiconduc tor is designed to be able to detect the presence of fluids using a probe. This chip requires a relatively high supply voltage and is not the most frugal power consumer. It is also quite specialised so unless you are buying in bulk the one-off price is not cheap. An alternative circuit show n h


water alarm schematic
Click here to download the full size of the above Circuit.

er e uses a standard CMOS IC type 74HC14. It has the advantage of operating with a 3 V supply and consumes less than 1 µA when the alarm is not sounding, this makes it ideal for use with batteries. The 74HC14 has six inverters with hysteresis on their input switching thresholds. A capacitor (C1) and a feedback resistor (R1) is all that`s necessary to make an inverter into a square wave signal generator. In the water alarm circuit the feedback resistor consists of R1 and the water sensor in series. R1 prevents any possibility of short-circuit between the inverter`s input and out-put. Resistor R2 defines the inverter`s input signal level when the sensor is not in water. Any open-circuit (floating) input can cause the inverter to oscillate and draw more current. The remaining inverters in the package (IC1. B to IC1. F) drive the piezo buzzer to produce an alarm signal. Capacitor C2 ensures that no DC current flows when the circuit is in monitoring mode (with the alarm silent) this helps reduce the supply current.




Leave Comment

characters left:

Related Circuits

  • New Circuits

    .

     


    Popular Circuits

    AM Transmitter
    7-MHz Loop Antenna
    moving message display
    Assembling The Speed Controller
    always on for pcs circuit
    Based on Bluetooth wireless transmission-reception circuit design schematics
    555 direct reading frequency meter schematic



    Top