18-bit ADC uses PC`s serial port


Posted on Sep 22, 2012

A PC usually requires a plug-in ADC card to process analog signals. However, with the circuitry in Figure 1, a PC can communicate with an 18-bit ADC through its serial port. The port provides both positive and negative power supplies as well as control signals. IC1 is an 18-bit MAX132 ADC with a serial interface. It requires three input control signals, , DIN, and SCLK, and emits serial data, DOUT, and EOC (end-of-conversion) signals.


18-bit ADC uses PC`s serial port
Click here to download the full size of the above Circuit.

An RS-232 port has three output lines: Pin 3 (TX), Pin 4 (DTR), and Pin 7 (RTS). TX generates the clock signal for the MAX132 and provides the negative power supply. DTR transmits serial data. RTS provides the CS signal and the positive power supply. Both the positive and the negative supplies use large capacitors for energy storage. When TX generates a clock signal or DTR sends a CS logic-low signal, the capacitors provide power to the MAX132. The MAX132 integrates everything except a reference that comes from a 1.2V LM385 voltage-reference diode, D1. The input-voltage range of the MAX132 is -512 to +512 mV. Listing 1 is a C program that displays the analog-to-digital-conversion result on-screen.





Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Motorized Remote control with ATMEGA328
Simple CB transmitter with BD329
IC-compatible crystal oscillator
Diode Sensor For Lasers
Inverse Heat Conduction
Multi-functional 100W Power Inverter with 5V USB
How To Build An Anti-Hijack Vehicle Alarm
It used to delay the monostable multivibrator circuit diagram of a continuous sequence



Top