Keyboard data-acquisition system


Posted on Feb 21, 2013

The most important criteria of a data-acquisition system for college science laboratories are simplicity and price rather than precision or speed. The data-acquisition system in Figure 1 offers adequate precision of less than 0.5% and speed of 1 Hz to replace the outdated laboratory chart recorder in student laboratories. You can install the system in 5 sec, operate it with a single toggle switch, and construct it for approximately $40. The only additional equipment necessary is a computer running Excel and an ATbus (not Universal serial bus), keyboard.



The system is simple to operate. After you install it between the keyboard and the PC, the keyboard functions normally until you close the toggle switch, which puts the circuit into "acquire" mode. The system then bypasses the keyboard and "




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Audio oscillator
Based on 51 single-chip design and production of infrared remote control car
single cycle datapath write to register and memory at same time
Dome Drive Schematic
8 channel thermocouple based temperature data logger
Op Amp Stereo Amplifier
Parallel Port Stepper Motor Driver With Discrete Components
Over-temperature alarm circuit
No linear feedback amplifier circuit a
Monostable circuit diagram of a light control
Switching solenoid drive circuit diagram



Top