http://www.next.gr/templates/cleancss/img/feed-esyndicat.pnghttp://www.next.gr/http://www.next.gr/converters/period-to-voltage/http://www.next.gr/converters/period-to-voltage/Period-To-Voltage-Converter-l14030.html The input signal drives ICD. Because ICD"s positive input (V+) is slightly offset to + 0.1 V, its steady state Mon, 11 Mar 2013 00:03:00 MSThttp://www.next.gr/converters/period-to-voltage/handy-voltage-to-time-converter-l4925.htmlThe circuit in Figure 1 is a simple, low-cost voltage-to-time converter using the ubiquitous 555 timer chip. You can use the IC`s monostable multivibrator as a voltage-to-time converter by connecting the analog-voltage input to the charging resistor, R, instead of connecting R to VCC. With this modification, the timer chip`s output-timing cycle, tP, is proportional to the input voltage, VIN. Thu, 28 Feb 2013 00:02:00 MSThttp://www.next.gr/converters/period-to-voltage/PULSE-PERIOD-TO-VOLTAGE-CONVERTER-l4927.htmlThis is a test circuit converts a square wave input signal into a voltage. But, the voltage produced is proportional to the time between edges (period) of the signal, not the frequency. The range is from 100uS to to 10mS, which produces a voltage from 100mV to 10 volts. Other scale factors are also possible. Fri, 09 Nov 2012 00:11:00 MSThttp://www.next.gr/converters/period-to-voltage/Circuit-converts-pulse-width-to-voltage-l4926.htmlThe circuit in Figure 1 converts pulse information to a clean dc voltage by the end of a single incoming pulse. In another technique, an RC filter can convert a PWM signal to an averaged dc voltage, but this method is slow in responding. Converting low-duty-cycle pulse information is slower yet. Sat, 01 Sep 2012 00:09:00 MST