Related circuits
Voltage-To-Frequency Converter With Optocoupler
In this circuit, a Raytheon RC4151 or National LM131 is used in conjunction with an optocou
Voltage Comparators
These two comparators are over- and under-voltage comparators. In Fig. 104-5(a), if Vm exceeds the reference voltage, t
Mosfet Buffer Amplifier Circuit
A MOSFET is used as a wideband buffer amplifier. T1 is wound on a toroid of approximately /f diameter, with material suitable for frequency (usually 1- to 20-MHz range). The turns ratio should be about 4:1 depending on load impedance. Typically, at 4 MHz, there are 18 turns on the primary,
Liquid level detector
When liquid level reaches both probes, alarm is turned on
Beam sputter for oscilloscope
The basis ofthe beam splitter is a 555 timer connected as an astable multivibrator. Signals at the two inputs are alternately displayed on the oscilloscope with a clear separation between them
Strain-gauge-instrumentation-amplifier
This circuit has an overall gain of 320. More gain can easily be obtained by lowering the value of R2. Untrimmed Vas is 10 11V. and Vas tempco is less· than O.lJIV/°C.
Sample and hold
The 2N4393 JFET was selected because of its low less (< 100 pA), very low ID (< 100 pA) and low pinchoff voltage
Auto Ignition Cut-Off
Using an SCR/relay combination, this circuit can be made to cut off ignition, unless a positive voltage is applied to
