Electronic Circuits Schematics Projects




4Watt UHF TV linear amplifier

Rating: 1.00/10 (36Votes cast)

Category: Inside Circuits
Views: 2692
Rank: 10

That Circuit is a UHF TV linear amplifier for small TV transmitters with output aroun 100-200mW. The transistor BGQ136 comes with SOT-122 case has gain of 13dB at 800MHz. So with input 100mW you get 2W output and for 200mW you get 4W.
4Watt UHF TV linear amplifier



Do not exceed that or you will start get bad distorted picture! Feed with 25 Volts/3Amps. Use Really big heatsink.


Datasheet file1: Click here to download BFQ136.pdf datasheet.


Related circuits

Canary Sound Simulator Circuit

This circuit generates the sound of two canaries singing in a cage. Two LM324 quad amps make up seven oscillators. One oscillator is an on/off control, the other six generate the sounds of two canaries.



Timer circuit

After one cycle of operation, SCR 1 will be on, and a low value of voltage is applied to the UJT emitter circuit, interrupting the tuning function. When pushbutton SI is pushed, or a positive going pulse is applied at point A, SCR 2 will turn on, and SCR 1 will be turned off by commutating...



Dc-latching-relay

The HllC supplies the de latching relay function and reverse polarity blocking, for currents up to 300 mA, depending on ambient temperature. For de use, the gate cathode resistor can be supplemented by a capacitor to minimize transient and dV/dt sensitivity. For pulsating de operation, the...



Sequential flasher

A 555 timer, IC1, drives a 4017 CMOS decade counter. Each of the 4017's first four outputs drives a CA3079 zero-voltage switch. Pin 9 of the CA3079 is used to inhibit output from pin 4, thereby disabling the string of pulses that IC normally delivers. Those pulses occur every 8.3 ms, i.e., at a...



Ready set goi

This game tests a player"s reaction time. It is activated by closing switch SI, which starts the tone generator and arms the circuit. The touchplate, labeled PLAY in the diagram, consists of two metal strips about l/16th-inch apart. The first player to bridge the gap with his or her finger turns...



Halogen-lamp-dimmer

This circuit is suitable for fitting into slide projectors without a dimmer facility as witb 24-Vac fed halogen lamps. With a few small alterations, it can also be used for dimming 12-V halogen lamps, but not those in a car, because these are fed from a de source. The circuit shown in Fig....



The Talking Compass Circuit

A talking compass is made up using a Hall-effect direction sensor (MODI) and an ISD1016 analog audio storage device. It is possible to program eight two-second announcements, for each of the eight main compass directions. The Talking Compass is comprised of a digital compass (MODI), and ISD1016...



Input-buffered-mixer

A high signal-to-noise ratio is important in signal construction and combination. The HA-5147 aids in lowering overall system noise and thereby raises system sensitivity. The signal combination circuit incorporates input bufferiug with several other features to form a relatively efficient...



How To BUILD The BEST HDTV ANTENNA!!!!

How to install a UHF masthead amplifier


Comments

4Watt UHF TV linear amplifier wrote on Feb 15, 2008
I cladding with the existing network but there [is] its substitution transistor is thank is not previous
Gane wrote on Jul 30, 2009
With printed coil it shall hardly work...Output "coil" on that freq is not simple coil...




 characters left

Captcha

captchaPlease input letters you see on the image.
Click on image to redraw.



Facebook Comments

Most searched
 
Accounts area
Username:
Password:
Forgot password? Register
Circuits