Electronic Circuits Schematics Projects




Car windshield wiper delay

Rating: 7.00/10 (37Votes cast)

Category: Inside Circuits
Views: 3543
Rank: 0

The circuit provides a windshield wiper delay, dynamic braking and windshield wipers when they reach the rest position. This prevents the blades passing, which could lead them to stop at a point where they interfere with the vision of drivers. With the original wiper switch off, switch turns on the MLS delay circuit and disconnects the wiring SIB from automobiles. When SI is turned off, the original wiring system and controls the delay circuit is bypassed.
Car windshield wiper delay



Regarding the SI uses the + 12 V to VI of the battery is a voltage doubler which produces + 18 V. This supply higher voltage is needed to ensure reliable turn on Ql through V2 multivibrator. This arrangement provides about +18 V to the gate of Ql, whose source is less than + 12 V drop V DS Ql. Ql stays on for a time determined by the interval between wipes WIPES potentiometervThe is controlled by the pause control when Cldrops below V + 4, U2 lights, turning on Ql and repeat the cycle.

Related circuits

2Meter Converter

This converter enables a receiver that tunes 28 to 32 MHz to receive the 144- to 148-MHz amateur band. A BF981 dual-gate



Fundamental-frequency-crystal-oscillator

For frequencies below 20 MHz, a fundamental-frequency crystal can be used and the resonant tank is no longer required. Also, at this lower frequency range the typical MECL 10,000 propagation delay of 2 ns becomes small compared to the period of oscillation, and it becomes necessary to use a...



100Khz crystal calibrator

This circuit is often used by amateur radio operations, shortwave listeners, and other operators of shortwave receivers to calibrate the dial pointer. The oscillator operates at a fundamental frequency of 100 kHz, and the harmonics are used to locate points on the shortwave dial, provided that...



Automobile-air-conditioner

This circuit disables the air conditioner compressor when additional engine power is required. It does so by monitoring the engine vacuum at the intake manifold. Ifthe vacuum drops to 40% of its normal level, the compressor clutch is disabled, removing the air conditioner load from the engine....



Wideband Preamp Circuit

Motorola MWA 110, 120, or 130 are wideband amplifier ICs. This wideband preamp circuit can be used in many applications. Keep the leads short when constructing the circuitry. PC board layout (shading represents copper) and parts layout. X is the feedthrough wire to the gound plane. All...



Capacitance operated alarm to foil purse snatchers

As long as touch plates (1) are touched together, the alarm is off. If not held for about 30 seconds, the alarm goes off. The circuit can be disabled with switch or by touching the plates (2)



Voltage Gauge

This circuit uses an RCA CA3162E (IC2) A/D converter. This converter has 12-bit output (BCD) which is sent to display decoder



Tv modulator

The VHF frequency is generated by a tuned Hartley oscillator circuit. Resistors R2, R3, and R4 bias the transistor, with tapped inductor LI and trimmer capacitor Cl forming the tank circuit. Adjusting Cl determines the frequency. Capacitor C2 provides positive feedback from the tank circuit to...



Common GM Wiper Problem

Windshield Wiper Motor Replacement : How to Troubleshoot a Broken Windshield ...


Comments




 characters left

Captcha

captchaPlease input letters you see on the image.
Click on image to redraw.



Facebook Comments

Most searched
 
Accounts area
Username:
Password:
Forgot password? Register
Circuits