Electronic Circuits Schematics Projects




Chime Circuit with 4049

Rating: 0.00/10 (13Votes cast)

Category: Inside Circuits
Views: 2815
Rank: 4

Resistor R1, capacitor C1, and two converters form a square wave generator, which produces the basic tone. The generator is sui followed by an inverter which serves as both a buffer and a driver for the President. The resistor R2, which has a minimum value of 100 ohms, limits the power and volume controls. The diode D1, capacitor C2, resistors R3 and R4, and two in converters to create the pulse generator which determines the power-up and decay times of the ring.
Chime Circuit with 4049



The circuit formed by decomposition of D2, C3, R5, and Q-reduces the amplitude of the carillon exponentially with time.


Datasheet file1: Click here to download 1N4001.pdf datasheet.

Datasheet file2: Click here to download CD4049.pdf datasheet.


Related circuits

Car alarm circuit using 555 timer

555 timer produces a guaranteed delay, allowing the driver to deactivate the alarm and the elimination of a control switch vulnerable outside.



Noise Generator Circuit

This circuit generates noise pulses that are suitable for test purposes, etc. A zener diode is used as a noise source. IC1 is a relaxation oscillator. PI determines noise bandwidth, and P2 and P3 the noise amplification.



TV modulator using a motorola MC1374

This one-chip modulator requires some outboard circuitry



Linear Vco

This VCO uses an LF356 op amp to produce a linear frequency vs. voltage characteristic using the CMOS HC4046. The frequency rang



Gasfet Frequency Doubler

This circuit will produce over +10 dBm in the 1800-3 000-MHz range. Drive power is 7 dBm in the 900-to-l 500-MHz r



50W-offline-switching-power-supply

The schematic shows a 50W power supply with a 5-V 10-A output. It is a flyback converter operating in the continuous mode. The circuit features a primary side and secondary side controller will full-protection from fault conditions such as overcurrent.



Microphone-amplifier

This circuit features the ZTX450/ZTX550 transistors in a push-pull output stage. The following readings were taken at maximum volume: Input: 0.4 mV rms, Output: 1.8 V rms, Voltage gain: 4500, Max. output before distortion: 2.25 V rms -supply current ~ 3.5 mA, Zero output-supply current: 3.5 mA,



Discrete-sequence-oscillator

The swept-frequency oscillator offers an inexpensive source of discrete frequencies for use in testing digital circuits. In this configuration, the circuit generates an 80-second seguence of eight frequencies, dwelling for 10 seconds on each frequency. You can change the dwell time or the...



Make this Small Homemade 50 Watt Inverter Circuit

74C14 Square Wave Oscillator


Comments




 characters left

Captcha

captchaPlease input letters you see on the image.
Click on image to redraw.



Facebook Comments

Most searched
 
Accounts area
Username:
Password:
Forgot password? Register
Circuits