Electronic Circuits Schematics Projects




Fast charge Controller with MAX712 / MAX713

Rating: 3.00/10 (33Votes cast)

Category: Inside Circuits
Views: 4335
Rank: 10

The MAX712 and MAX713 are nickel cadmium (Ni-Cd) battery fast charge controllers which will fast charge batteries from a DC source at least 1V higher than the maximum battery voltage. 1 to 16 series cells can be charged at rates up to 4C. A voltage-slope detecting analogue-to-digital converter, timer, and temperature window comparator determine charge completion. The MAX712 or 713 are powered by the DC source via an on-clip +5V shunt regulator, and draw a maximum of 5uA from the battery when not charging. A low-side current-sense resistor allows the battery charge current to be regulated while still supplying the power to the battery's load.
Fast charge Controller with MAX712 / MAX713



The MAX712 terminates fast charge by detecting zero voltage slope, while the MAX713 uses a negative voltage-slope detection scheme. Both devices are identically packaged as 16-pin DIL and share the same pin numbering and basic functions. An external power


Datasheet file1: Click here to download MAX712-MAX713.pdf datasheet.

Datasheet file2: Click here to download 2N6109.pdf datasheet.

Datasheet file3: Click here to download 1N4001.pdf datasheet.


Related circuits

Permanent Magnet Detector

In this circuit, oscillator Ql runs at about 15 kHz and feeds mixer Ul. Ul has an internal oscillator that runs a



Battery-powered-ground-noise-probe

Oscilloscope measurements of ground noise can be unreliable because noise can enter your circuit via the scope"s three-pronged power plug. You can avoid this problem by using the ground-noise tester shown. Powered by two 9-V batteries, the circuit dissipates power only while push-to-test switch...



Low-Frequency Multiplier

This circuit uses a comparator as a Schmitt trigger (311H) and two active bandpass filters (LM318H). 3-kHz output



Digital Altimeter Circuit

A pressure sensor (IC4) is used with a dc: amplifier to convert the bridge output (IC4) to a single-ended voltage. ICld provides a reference voltage for setting barometric pressure. IC3 is an A/D converter manufactured by Intersil. This drives an LCD module. Calibration reads out in fact.



100 Mhz converter

The 2N4416 JFET will provide noise figures of less than 3 dB and power gain of greater than 20 dB. The JFET's outstanding low crossmodulation and low intermodulation distortion provides an ideal characteristic for an input stage. The output feeds into an LM171 used as a balanced mixer.



Medical instrument preamplifier

Input current (from sensors connected to the patient) is limited to less than 5 ยต under fault conditions.



Solid State Relay circuits

This dark-activated relay switch can be used to turn on walkway or other outdoor lighting at dusk. By using alternate connections to A and B, increasing illumination,



Hf Low-Power Cw Transmitter

Suitable for amateur use, this 1.5-W transmitter runs on a 12-V supply. Ql is an oscillator using a surplus FT2



DIY Mini Solar Charger & Home Made Charge Controller for small Battery Pack

DIY Solar Panel System Wiring Diagram


Comments




 characters left

Captcha

captchaPlease input letters you see on the image.
Click on image to redraw.



Facebook Comments

Most searched
 
Accounts area
Username:
Password:
Forgot password? Register
Circuits