Electronic Circuits Schematics Projects




Fully adjustable preamplifier

Rating: 4.00/10 (84Votes cast)

Category: Inside Circuits
Views: 4651
Rank: 0

This circuit is a audio preamplifier tha has balance, tone and loudness controls. It should be suitable as an example of good design for audio application.
Fully adjustable preamplifier



Uses the BAA730 and NE540 chips.

Related circuits

Inexpensive Vhf/Uhf Diode Rf Switch

This circuit uses low-cost IN4148 diodes and exhibits about 1.5 dB insertion loss from 10 to 1000 MHz w



Audio noise generator

This simple circuit generates both white and pin noise. Transistor Q1 is used as a zener diode. The normal base-emitter junction is reverse-biased and goes into zener breakdown at about 7 to 8 volts. The zener noise current from Q G flows into the base of Q2 such that an output of about 150...



Active crossover circuit with TL074

An audio source, like a mixer, preamp, EQ, or a recorder, is fed to the input of the Electronic Crossover Circuit. This signal is either AC or coupling, depending on the setting of switch 51, the non-inverting input of buffer amplifier Ul-a, a section of a quad BIFET, low amp TL074 noise made by...



Electronic coin tosser

The circuit shown simulates the flipping of a coin by merely pushing switch PB1



Low-Frequency Lc Oscillator

Basically a Hartley oscillator using a triple-emitter follower, this oscillator can be used at audio and low ra



A/D Board

An IBM PC can operate the two 12-bit A/D converters in Fig. 1 via its printer port. The converters" serial outputs use only two o



10 Minute Id Timer

Designed to automatically identify a transmitter every 10 minutes, this 555 circuit has adjustable charge and discharge



Transistorized Bar-Graph Driver

A resistor network (Rl through RIO) with emitter followers (Ql and Q2) drives LED drivers (Q3 through Q7).



Articles & Projects
DCF77 Preamplifier Circuit Diagram. A popular project among microcontroller aficionados is to build a radio-controlled clock. Tiny receiver boards are available, with a pre-adjusted ferrite antenna, that receive and demodulate ...

The following chart is a simple two-line preamp with 12AU7 / ECC82 tube. The general gain of the circuit is about eight , The 2nd segment of the circuit is a cathode followers and a low impedance amplifier. This circuit is from ...

DCF77 Preamplifier Circuit. Posted by fentanamu sanyu Saturday, April 13, 2013 0 comments. A in style undertaking amongst microcontroller aficionados is to build a radio-controlled clock. Tiny receiver boards are available, with a ...

DCF77 Preamplifier Circuit Diagram. A popular challenge amongst microcontroller aficionados is to build a radio-controlled clock. Tiny obtainr boards are on hand, with a pre-adjusted ferrite antenna, that obtain and ...

n recent years, following CDs introduction, vinyl recordings are almost disappeared. Nevertheless, a phono preamplifier is still useful for listening old vinyl discs from a well preserved collection. This simple but efficient circuit ...

This Hi Fi stereo preamplifier ambit is congenital with TDA1054 IC from SGS. TDA1054 is a 16-pin DIL amalgamation and integrates 2 abstracted preamp circuits. It is a low babble preamp with little or no botheration in the ...

CDC ElEcTroNic Work Shop - 741 Opamp based Mic Preamp.avi

Logitech z130 Hack: Pre-amp Circuit and Assembly


Comments




 characters left

Captcha

captchaPlease input letters you see on the image.
Click on image to redraw.



Facebook Comments

Most searched
 
Accounts area
Username:
Password:
Forgot password? Register
Circuits