The circuit is based on the known chip TDA1524, which is an integrated control Volume, Bass, treble, and Balance. These arrangements are made through 4 potentiometers (P5-P8) with trend. The integrated circuit IC1, to run the needed very few external components. The potentiometer PI-P4 are used to compensate any tolerances POSTS components that regulate the input signal. The input circuit is 5 points and 8 & 10 & 10. The output of the circuit is 7 points and 6 & 10 & 10. To supply to point 9 is a positive trend and 10 negative. Sections 1, 2, 3, 4, 11 and 15 are used for optional remote control circuit.
The P5 potentiometer adjusts the low frequencies (BASS), while PO tensiometro P6 regulates high frequencies (TREBLE). Similarly, P7 potentiometer adjusts the volume (VOLUME) and the P8 BALANCE. Finally, the potentiometer P1 - P4 micrometer adjust various settings. So when the Volume (potentiometer P7) is positioned for zero output, the output is actually zero. Similarly, when the two output signals at the same level level, the potentiometer's Balance (P8) is in the middle. Similarly, regulated and Bass and Treble knobs.
Parts and Components:
R1,R2,R6,R7=82K 1/4w 5%
R5=33K 1/4W 5%
R3,R4=220 1/4W 5%
PI-P4=22K Trimmer
P5-P8=47K Potentiometers
C1,C2,C11,C14=100nF polyester
C3,C12=22uF/16V electrolytic
C4,C8=15nF polyester
C5,C10=56nF polyester
C6=100uF/16V electrolytic
C7,C9=4,7uF/16V electrolytic
C13=220nF polyester
IC1=TDA1524 Chip
IC base 18 DL
