Electronic Circuits Schematics Projects




Magnetic Cartridge Preamplifier (LT1028CN8)

Rating: 2.00/10 (83Votes cast)

Category: Inside Circuits
Views: 4928
Rank: 10

A high performance op-amp that sets a new standard of excellence in noise performance only 0.9nV/Hz with low source resistances. Total harmonic distortion is less than 0.01%. The op-amp is suitable for use in high quality audio, low noise frequency synthesizers, infrared detectors etc.
Magnetic Cartridge Preamplifier (LT1028CN8)



Particularly where the source resistance is under 1Kohm.


Datasheet file1: Click here to download LT1028.pdf datasheet.


Related circuits

Digital transmission isolator

An optoelectronics device is used to couple a digital (TTL) signal to another system. The photodiode in the optocoupler drives an LM311 set up to produce a TTL compatible output.



Fet voltmeter

This FETVM replaces the function of the VTVM while at the same time ridding the instrument of the usual line cord. In addition, drift rates are far superior to vacuum tube circuits allowing a 0 volt full scale range which is impractical with most vacuum tubes.



Harmonics-generator

Two comparators and a summing amplifier that generate differential harmonic spectra comprise a simple frequency multiplier. The resulting circuit can extract harmonics from a sine, triangle, sawtooth, or any other sloping-sided waveform. With a sloped-input waveform, a comparator produces an...



Interface

Circuits to interlace the Si7135 directly with two popular microprocessors are shown in Figs. 18-2a and b. The 8080/8048 and the MC6800 families with 8-bit words need to have polarity, overrange, and underrange multiplexed onto the digit 5 word. In each case, the microprocessor can instruct the...



Long-Duration Time Delay

Transistor Ql and resistors Rl, R2, and R3 form a constant current source and the charge current might be adjusted



Canary Sound Simulator Circuit

This circuit generates the sound of two canaries singing in a cage. Two LM324 quad amps make up seven oscillators. One oscillator is an on/off control, the other six generate the sounds of two canaries.



Low distortion audio gain limiter

The level at which the limiter kicks in audio can be adjusted with the selector knob LIMIT LEVEL. When this level is exceeded, the output of the half-LIMITING detector of the op-amp (used as a comparator) turns the LED causes the resistance of the photoresistor to decline rapidly. It is in tum...



Short Tester For 120V Equipment Circuit

Do you deal with old equipment in unknown condition If so, this little circuit could keep you from causing further harm



Audio Preamp and Amplifier Circuit Using LM358

Logitech z130 Hack: Pre-amp Circuit and Assembly


Comments




 characters left

Captcha

captchaPlease input letters you see on the image.
Click on image to redraw.



Facebook Comments

Most searched
 
Accounts area
Username:
Password:
Forgot password? Register
Circuits