Electronic Circuits Schematics Projects




Microphone preamplifier with TLC251

Rating: 1.00/10 (75Votes cast)

Category: Inside Circuits
Views: 4532
Rank: 0

A microphone preamplifier using: om CMOS op amp with its own battery, is small enough to be placed in a case of small microphone. The amplifier operates from a 1.5V battery cathode mercury low supply currents. This preamp will operate at very low power and maintain a reasonable frequency response as well. The TLC251 is operating in low bias (operating at 1.5 V) draws a supply current of only 10 and has a year - frequency response of 3 dB 27 Hz to 4.8 kHz. With 8-pin grounded, which is designated as the polarization state high limit increases above 25 kHz.
Microphone preamplifier with TLC251



Supply current is only - 30 pA under these conditions.

Related circuits

Low-power-rs-232c-driver

This circuit draws only 4 mA from a 5-V supply while driving a standard RS-232C receiver. The system clock drives a de-de converter that produces -3.4 V. The frequency can range from 0.5 to 8 MHz, but a range of 0.5 to 1 MHz will minimize power dissipation. The circuit output withstands direct...



10Mhz universal counter

This is a minimum component complete Universal Counter. It can use input frequencies up to 10 MHz at INPUT A and 2 MHz at INPUT B



Window-detector

This circuit de-energizes a normally energized relay if the input voltage goes above or below two individually set voltages. The transistor driving the relay is normally turned on by R4, so the relay is normally energized. Ifthe cathode of Dl or D2 is taken negative, Ql will turn off and the...



Dynamic Audio Mixer

The dynamic mixer combines two audio inputs by adding the primary signal, Input A, to a gain-controlled signal, Input B



Ready set goi

This game tests a player"s reaction time. It is activated by closing switch SI, which starts the tone generator and arms the circuit. The touchplate, labeled PLAY in the diagram, consists of two metal strips about l/16th-inch apart. The first player to bridge the gap with his or her finger turns...



Toxic gas detector

The major device in the circuit is SRI (a TGS812 toxic-gas sensor manufactured by Figaro Engineering Inc.) The gas-sensitive semiconductor (acting like a variable resistor in the presence of toxic gas) decreases in electrical resistance when gaseous toxins are absorbed from the sensor surface. A...



Regulated-driven-converter

This converter delivers up to 50 mA from a 6-V battery with 78% efficiency. This flyback converter functions by feedback-controlling the frequency of inductive flyback events. The inductor"s output, rectified and filtered to de, biases the feedback loop to establish a stable output. If the...



Ultra-precision-instrumentation-amplifier

This circuit will run from a single 5 V power supply. The LTC1043 switched-capacitor instrumentation building block provides a differential-to-single-ended transition using a flying-capacitor technique. Cl alternately samples the differential input signal and charges ground referred C2 with...



CDC ElEcTroNic Work Shop - 741 Opamp based Mic Preamp.avi

Operational Amplifier Tutorial & super microphone circuit


Comments




 characters left

Captcha

captchaPlease input letters you see on the image.
Click on image to redraw.



Facebook Comments

Most searched
 
Accounts area
Username:
Password:
Forgot password? Register
Circuits