Electronic Circuits Schematics Projects




Modem shutdown Indicator

Rating: 6.00/10 (73Votes cast)

Category: Inside Circuits
Views: 230
Rank: 2

The circuit has been designed to accommodate all those who dedicate many hours of their lives by exploring the endless pages of this site. Despite the fact that it consists of only three components (Most were not little!), Is able to provide an indication of whether it actually released the telephone line after a long connection via modem to the network. This can be particularly useful, since there In many cases, the computer claims that the telephone network connection has been interrupted, but the modem for some reason keeps the line engaged.
Modem shutdown Indicator



Symvoulemomenoi indications of this simple circuit you save by unwanted `blocks` of your phone, while ensuring that the end of two months the account will is reasonable. The circuit is based on the specificity of the line to keep a potential that the rest reaches 40 or 50 V. The same line, that when some conference, 'throw' the trend is sharply to about 1 A n.

Related circuits

Rc Decade Box Circuit

This decade box can be set for any resistance value between 10 and 11.1 in 10- stops. A switch can be used to configure several RC configurations. Use close tolerance components in the circuit. If possible, check components with-an accurate bridge or other means to ensure accuracy. THE VARIOUS...



Frequency divider

If the input frequency is known, the timer can easily be used as a frequency divider by adjusting the length of the timeing cycle. Figure shows the waveforms of the timer when used as a divide-by-three circuit.



Phone-recorder

This recorder can be connected to the telephone lines just about any place, and no external power source is needed. The tape recorder"s switch terminals are applied to a pair of transistors, connected as Darlingtons, that are used to turn the recorder on and off. When the telephone is off-hook...



Pierce harmonic oscillator 100Mhz

Current meter ranges from 100 pA to 3 mA full scale. Voltage across input is 100 µV at lower ranges rising to 3 mV at 3 mA. The buffers on the op amp are to remove ambiguity with high-current overload



Digital transmission isolator

An optoelectronics device is used to couple a digital (TTL) signal to another system. The photodiode in the optocoupler drives an LM311 set up to produce a TTL compatible output.



Pulse-position modulator

The threshold voltage, and thereby the time delay, of a free-running oscillator is shown modulated with a triangular-wave modulation signal



Loop Antenna Preamplifier Circuit

This preamplifier has a built-in regeneration control boost gain selectivity. CI is a single or multi-gang AM broadcast-band tuning capacitor. LI is a ferrite loop antenna, tapped at about 15 to 25% of total turns. This circuit should prove useful for low-frequency (up to 3 MHz) reception,



S Meter For Communications Receivers Circuit

Because many amateur receivers are fitted with an S meter that functions far from logarithmically, the proposed circuit should be a welcome extension of such receivers. Although ICs such as the CA3089 or the CA3189 are not in common use anymore, they serve a useful purpose in the meter circuit,...



Hame MPR-A1 5 in 1 3G Mobile Wireless Router Broadband Power WiFi Hotspot to ...


Comments




 characters left

Captcha

captchaPlease input letters you see on the image.
Click on image to redraw.



Facebook Comments

Most searched
 
Accounts area
Username:
Password:
Forgot password? Register
Circuits