Electronic Circuits Schematics Projects




Photocell power supply (MAX630)

Rating: 2.00/10 (60Votes cast)

Category: Inside Circuits
Views: 122
Rank: 0

This circuit delivers either 4.8 or 7.2 V regulated at 15 mA with a 3-V input from a bank of photocells. R1 should be 453 k? for a 7.2-V output and 274 k? for a 4.8-Vdc output. Regulator efficiency is around 70%.
Photocell power supply (MAX630)



This should be considered when selecting suitable solar cells.

Related circuits

High output 600 Ohm line driver

The circuit has a "floating" output, i.e., it behaves like an isolated transformer winding, with the output amplitude remaining unchanged whether the center or either end of the load is grounded. This is achieved by making Z-out, common mode, infinite. The circuit consists of two current-sources...



Audio input selector circuit (4416 CMOS)

CMOS switches are used directly to select the entries in the audio circuits, it can introduce unacceptable levels of distortion, but if the switch is included in the feedback network of an op amp, the distortion due to the switch may be virtually eliminated. The circuit uses a CMOS switch 4416,...



Carrier-current-am-receiver

The AM Tuned Radio Frequency (TRF) receiver, has a sensitivity of about 1 m V at tbe input for an audio output of "iz W. Capacitor C22 couples audio signals from the power line to the PC board-it must be rated at 600 Vdc. R8 will cause F1 to blow, if C22 shorts. The signal from C22 goes to a...



Short wave radio for PC

This Cheap circuit will amaze you with its wide range recieving signal between 6 and 17Mhz (49-19meters). Power supply is not necesery, just connect it to your pc, place the antena to your home piping network and voila!



Security-door-ajar-alarm

In operation, the TL3019 device will activate, or become low, when a south pole of a magnet comes near the chip face of the device. The example shows five doors. Each door has a magnet embedded in its edge with the south pole facing the outer surface. At the point where the magnet is positioned...



Stand-by power for non-volatile cmos rams

To prevent loss of data when a CMOS RAM is switched from normal operation (Vcc = 5 volts) to stand-by mode (Vcc = VBAT) it must be ensured that the CS pin goes near the Vcc rail at all times. Ac coupling to the chip select is made through capacitor C, breaking the dc current path between Vqq (and...



Cmos-universal-logic-probe

Only the CD4009AE hex buffer, two resistors, and two LEDs are required for a logic probe. CMOS logic probe features 10120 input impedance and covers 3 to 15 V range.



Transistorized Am Radio Circuit

Shown is a schematic of a typical transistor AM radio. This circuit uses npn transistors. The circuit is generic; therefore, no specific values are given for some components.



DIY automatic light regulator

Automated Light Controller with adjustable Sensitivity and Hysteresis


Comments




 characters left

Captcha

captchaPlease input letters you see on the image.
Click on image to redraw.



Facebook Comments

Most searched
 
Accounts area
Username:
Password:
Forgot password? Register
Circuits