Electronic Circuits Schematics Projects




Small current amplifier circuit

Rating: 0.00/10 (68Votes cast)

Category: Inside Circuits
Views: 878
Rank: 0

To amplify the small current signals as an electron collector inside a vacuum chamber, it is convenient for reasons of noise and bandwidth to have a `head-amplifier` attached to the chamber. Op N-amp 1 is a precision device with bipolar bias current and low offset voltage (1)-and the noise low, which allows the 100:1 attenuator comments to be used..
Small current amplifier circuit



The resistor R3 can vary by more than 10 million to less than 1 k, and so the nominal value from 0 to 1 V output signal peak corresponds to the input current ranges from 1 nA to 10 pA.

Related circuits

Voltage-To-Frequency Converter With Optocoupler

In this circuit, a Raytheon RC4151 or National LM131 is used in conjunction with an optocou



Active Antenna Ii

This circuit provides 14- to 20-dB gain at frequencies from 10 kHz to 30 MHz. The antenna length can be anything between



Delayed Pulse Generator Circuit

Three 555 IC timers are used in this circuit to construct a simple delayed-pulse generator. IC1 acts as a waveform shaper to produce a rectangular waveform. IC2 produces a delaying pulse to trigger 103 on the trailing edge of the delaying pulse. Rl controls delay time and R2 controls pulse width.



Negative Voltage From A Positive Supply

By using a 555 timer to generate a square wave and voltage-doubling the output, a negative voltage



Optical schmitt trigger

This circuit shows a 555 with its trigger and threshold inputs connected together used to energize a relay when the light level on a photoconductive cell falls below a preset value



Visual Cw Offset Indicator

An NE567 tone decoder, tuned to the transceiver"s CW offset frequency, ensures that the transceiver will be tran



Tandem dimmer

This cross fader circuit can be used for fading between two slide projectors. As R3 is moved to either side of center, one triac is fired earlier in each half cycle, and the other iater.



Audio Dynamic Noise-Reduction System Circuit

Ul is a dedicated IC (National Semiconductor) that achieves up to 10 dB noise, reduction by an adaptive bandwidth scheme



Tutorial: How to design a transistor circuit that controls low-power devices

Electronic Circuits - General Amplifier Theory 1 - Gain


Comments




 characters left

Captcha

captchaPlease input letters you see on the image.
Click on image to redraw.



Facebook Comments

Most searched
 
Accounts area
Username:
Password:
Forgot password? Register
Circuits