Electronic Circuits Schematics Projects




Square wave oscillator as wire tracer

Rating: 4.00/10 (57Votes cast)

Category: Inside Circuits
Views: 3062
Rank: 0

The tracer works by placing a square-wave signal ?n the line to be traced, The square wave is full of harmonics. ? small radio placed close to a wire carrying this signal will buzz.
Square wave oscillator as wire tracer



The radi, therefore, is used as a probe to trace out the wire.

Related circuits

Low power audio amplifier

The amplifier operates from supplies ranging up to 12 volts, and operates (with reduced volume) from supply voltages as low as 1.8 volts without having distortion rise to unacceptable levels. (Its power requirements make it suitable for solar-cell application.) Components external to the...



Rf-probe

Transistor Q1-configured as a source-follower buffer stage, offering a bit under unity voltage gaingives tbe unit a high-impedance input of about 1 MO shunted by about 10 pF, which keeps only minimal loading on tbe equipment being tested. C1 serves as input de blocking capacitor. The Q1 output...



Delayed pulse generator

The circuit offers independent control of initial delay and pulse rate. ICIc is connected as a pulse generator whose operation is inhibited by the normally low O/P of the ICla. When the circuit input goes low i.e., by pressing PB1, IClb O/P goes high and the circuit O/P goes low thus replicating...



Electronic keyer

This circuit automatically produces Morse code dots and dashes set by time constants involving Cl and C2. Rl sets dot/dash ratio and R2 sets the speed



Infrared Receiver Circuit

The circuit operates from a 5-V supply arid has a current consumption of 2 mA. The output is a current source that drives or suppresses a current of more than 75 with a voltage swing of 4.5 V. The Q-killer circuit eliminates distortion of the output pulses because of the decay of the tuned...



Lamp-flasher

The circuit is built around two power FETs, which are configured as a simple astable multivibrator to alternately switch the two lamps on and off. The rc values given sets the flash rate to about 1/3 Hz. By varying either the resistor or capacitor values, almost any flash rate can be...



Ssb/Cw Product Detectors

These circuits are used for product detection of single-sidebound (SSB) and CW signals. BFO injection is typically



Wien bridge oscillator

Field effect transistor, Ql, operates in the linear resistive region to provide automatic gain control. Because the attenuation of the RC network is one-third at the zero phase-shift oscillation frequency, the amplifier gain determined by resistor R2 and equivalent resistor R1 must be just equal...



Beginner level circuits - 555 square wave/pulse/clock generator

DIY Square-Wave Generator (Musical Electronics - 3)


Comments




 characters left

Captcha

captchaPlease input letters you see on the image.
Click on image to redraw.



Facebook Comments

Most searched
 
Accounts area
Username:
Password:
Forgot password? Register
Circuits