Electronic Circuits Schematics Projects




Switching Regulator with L4972A

Rating: 7.00/10 (57Votes cast)

Category: Inside Circuits
Views: 3994
Rank: 10

The LA9472A is a 2A monolithic step down switching regulator operating in continuous mode and realized in a new BCD technology allowing the integration of isolated, vertical DMOS power transistors with mixed CMOS/bipolar transistors. The device can deliver 2A at an output voltage adjustable from 5.1V to 40V and contains diagnostic and control functions that make it particularly suitable for microprocessor based systems.
Switching Regulator with L4972A



Integrated functions include a reference voltage of 5.1V at 2%, soft start, under-voltage lockout, an oscillator with feed-forward control, pulse by pulse current current limit, thermal shutdown and a reset and power failure circuit. The latter provides a


Datasheet file1: Click here to download L4972A.pdf datasheet.

Datasheet file2: Click here to download SB560.pdf datasheet.


Related circuits

Ultrasonic-pest-controller

This circuit consists of two basic parts: an oscillator tuned to 40kHz, and a voltage doubler with pulse generator. The pulses are about 10 ms long and occur 2-3 per s to reduce battery drain and increase the annoyance factor for a cat, dog, hedgehog, etc.



Electronic-bird-chirper

Transistors Ql and Q2 form the two halves of a free-running multivibrator whose frequency is determined by the voltage across C8. That capacitor is charged and discharged by closing and openingBwitch Sl. Transistors Q3 and Q4 make up a VFO. The output of the free-running multivibrator frequency...



FM (prm) optical transmitter

The basic circuit can be operated at 80 kHz and is limited by the PUT capacitor combination. 60 kHz is the maximum modulation frequency. The pulse repetition rate is a linear function of Vin, the modulating voltage. Lenses or reflectors minimizes stray light noise effects. Greater output can be...



5V 0.5A power supply

The circuit is essentially a constant source modified by the feedback components R2 and R3 to give a constant voltage output. The output of the ZN424E need only be 2 volts above the negative rail, by placing the load in the collector of the output transistor Tr2. The current circuit is achieved...



Low-frequency-converter

Among the signals below 550 kHz are maritime mobile, distress, radio beacons, aircraft weather, European Longwave-AM broadcast, and point-to-point communications. The low-frequency converter converts the 10 to 500kHz LW range to a 1010 to 1550kHz MW range, by adding 1000kHz to all received...



Gain-Controlled Amplifier

This single-chip circuit adjusts its audio gain according to the ambient noise picked up by the microphone. When



Crystal-controlled oscillator for ssb

This oscillator may contain several switched crystals to provide channelized operation.



Rain warning beeper

One small spot of rain on the sense pad of this bleeper will start this audio warning. It can also be operated by rising water. The circuit has two transistors, with feedback via capacitor Cl, but Trl cannot operate as long as the moisture sense pad is dry.



Free Circuit Diagrams - Self Switching Power Supply

Switching Regulator Circuit


Comments




 characters left

Captcha

captchaPlease input letters you see on the image.
Click on image to redraw.



Facebook Comments

Most searched
 
Accounts area
Username:
Password:
Forgot password? Register
Circuits