Electronic Circuits Schematics Projects




Sun - Up Alarm with 4011

Rating: 0.00/10 (45Votes cast)

Category: Light Laser LED Circuits / Light Sensing
This circuit is also crossed to: Light Sensing Circuits
Views: 2500
Rank: 0

The Sun - Up Alarm can be used to provide a audible alarm for when the sun comes up or it can be used in a dark area and detect when a light comes on. It can also be used to detect a light beam, headlights etc. The circuit works as follows. The phototransistor is very sensitive to light. (Any phototransistor will work fine) The sun shining on this device will provide a high to one of the NAND gates. This will cause another NAND gate to oscillate which will drive another gate to output a 100hz tone. The transistor provides drive for the speaker. visit page.
Sun - Up Alarm with 4011



Related circuits

Music Light Show

The circuit connects to the speaker outputs of your stereo or to the back of your speaker. The music passes through the transformer and the volume level is adjusted by the 5k ohm pot. Each light bulb is turn on by a different frequency of sound based on the resistor & capacitor combination in the...



LINE POWERED XENON FLASH TRANSMITTER

This line powered xenon flash circuit drives a small camera type flash tube. It has an optical isolator to allow the flash to be safely triggered from some remote device. A flash rate of 2Hz is possible with the circuit.



Pulse generation by interrupting a light beam

This circuit puts out a pulse when an object on the conveyor belt blocks the light source. The light source keeps the phototran-sistor turned on. This produces a high-logic-level voltage at the Schmitt-trigger inverter and a TTL-compatible low logic level at pin 5 of the monostable



Light sensor for oscilloscope

This circuit is a simple visible light or IR detector for testing any equipment which outputs light. The circuit can be also used for measuring ambient light levels. This circuit is based on one photodiode which is used in photocell mode so that the photodiode generates a voltage and current...



1uS LIGHT PULSE DISCRIMINATOR PLUS F TO V CONVERTER

This circuit is designed to detect the narrow 1uS pulses produced by the above amplifier circuit. The clean logic type pulses produced by the discriminator are then sent to a frequency to voltage converter. The circuit is designed to process a pulse frequency of 10KHz that is frequency modulated...



1 WATT FLUORESCENT LAMP NIGHT LIGHT

If you are tired of replacing small night light lamps, try this circuit. The line powered circuit uses a long life cold cathode fluorescent lamp. A simple charge pump technique runs the lamp without any transformer.



200W Lamp Flasher with 555 timer

200W Lamp Flasher is used to flash lamps, bulbs and halogen lamp to give your product that attracting look.



100M-baud-fiber-optic-receiver

This two-chip receiver with minimum external component count has been designed for low-cost fiber optic applications to 100-M baud (50 MHz). The receiver is divided into pre-and postamplifier !Cs for increased stability. The preamplifier IC features low noise with a differential transresistance...



Wakeup on Day Light Alarm Circuit and Explanation

Dodge vs. GMC vs. Nissan at Spring Creek


Comments




 characters left

Captcha

captchaPlease input letters you see on the image.
Click on image to redraw.



Facebook Comments

Most searched
 
Accounts area
Username:
Password:
Forgot password? Register
Circuits