Electronic Circuits Schematics Projects




XENON LAMP FLASH DETECTOR

Rating: 2.00/10 (8Votes cast)

Category: Light Laser LED Circuits / Light Sensing
This circuit is also crossed to: Xenon
Views: 5542
Rank: 2

This circuit uses a small 2.5mm square photo diode in conjunction with a 100mH coil to detect the short light flashes from a xenon lamp. The coil makes the circuit immune to normal room lights. Its 10mv sensitivity can detect light flashes from a range of over 100 feet. Reflections from a rooms walls and ceiling is usually enough to trigger the circuit. The entire circuit draws only 3 Microamps from a 6 to 9 volt battery. visit page.

Related circuits

SINGLE IC FORMS SENSITIVE MODULATED LIGHT RECEIVER

The circuit uses a very inexpensive C-MOS IC that is connected to a small photodiode. Using a unique inductive feedback network, the circuit provides high sensitivity under high ambient light conditions. It is a great circuit when you want to extend the range of an optical remote control...



FM (prm) optical transmitter

The basic circuit can be operated at 80 kHz and is limited by the PUT capacitor combination. 60 kHz is the maximum modulation frequency. The pulse repetition rate is a linear function of Vin, the modulating voltage. Lenses or reflectors minimizes stray light noise effects. Greater output can be...



12VDC Fluorescent Lamp Driver

A number of people have been unable to find the transformer needed for the Black Light project, so I looked around to see if I could find a fluorescent lamp driver that does not require any special components. I finally found one in Electronics Now. Here it is. It uses a normal 120 to 6V stepdown...



Dark-activated 230V Lamp

This device allows one or more lamps to illuminate at sunset and turn off at dawn. Q1 and Q2 form a trigger device for the SCR, providing short pulses at 100Hz frequency. Pulse duration is set by R2 and C1. When the light hits R1, the photo resistor assumes a very low resistance value, almost...



12V stroboscope

This is one of my stroboscope designs. Usually many stoboscope circuit work directly from mains voltage, but this circuit uses 12V DC intead od mains AC. This is very good idea if you don`t want to mess with direct mains voltage connected circuit or you want to run the stroboscope from batteries....



XENON LAMP FLASH DETECTOR

This circuit uses a small 2.5mm square photo diode in conjunction with a 100mH coil to detect the short light flashes from a xenon lamp. The coil makes the circuit immune to normal room lights. Its 10mv sensitivity can detect light flashes from a range of over 100 feet. Reflections from a...



Tape Head Demagnetizer

This model charges up a capacitor to a pre-determined voltage and then dumps it into a demagnetizer oscillator using an SCR. The LED lights when finished:



Pulse generation by interrupting a light beam

This circuit puts out a pulse when an object on the conveyor belt blocks the light source. The light source keeps the phototran-sistor turned on. This produces a high-logic-level voltage at the Schmitt-trigger inverter and a TTL-compatible low logic level at pin 5 of the monostable



Car Music Sensor Light?auto music light Guangzhou Liwin Electronic Technology...

How to use a Multimeter for beginners: Part 1 - Voltage measurement


Comments




 characters left

Captcha

captchaPlease input letters you see on the image.
Click on image to redraw.



Facebook Comments

Most searched
 
Accounts area
Username:
Password:
Forgot password? Register
Circuits