Very simple Delay circuit!


Posted on Aug 8, 2012

The two circuits di atas illustrate opening a relay contact a short time after the ignition or ligh switch is turned off. The capacitor is charged and the relay is closed when the voltage at the diode anode rises to 12 volts. The circuit on the left is a common collector or emitter follower and has the advantage of one less part since a resistor is not needed in series with the transistor base. However the voltage across the relay coil will be two diode drops less than the supply voltage, or about 11 volts for a 12.5 volt input.



Very simple Delay circuit! - image 1
Click here to download the full size of the above Image.

The common emitter configuration on the right offers the advantage of the full supply voltage across the load for most of the delay time, which makes the relay pull-in and drop-out voltages less of a concern but requires an extra resistor in series with transistor base. The common emitter (circuit on the right) is the better circuit since the series base resistor can be selected to obtain the desired delay time whereas the capacitor must be selected for the common collector (or an additional resistor used in parallel with the capacitor). The time delay for the common emitter will be approximately 3 time constants or 3*R*C. The capacitor/resistor values can be worked out from the relay coil current and transistor gain. For example a 120 ohm relay coil will draw 100 mA at 12 volts and assumming a transistor gain of 30, the base current will be 100/30 = 3 mA. The voltage across the resistor will be the supply voltage minus two diode drops or 12-1.4 = 10.6. The resistor value will be the voltage/current = 10.6/0.003 = 3533 or about 3.6K. The capacitor value for a 15 second delay will be 15/3R = 1327 uF. We can use a standard 1000 uF capacitor and increase the resistor proportionally to get 15 seconds.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Precision battery voltage monitor
30w power amp tda2040 schematic
2 channel 100W min AF Power Amplifier STK4231II
tv transmitter circuit
5v to isolated 5v converter circuit
NTSC RGB Cable Schematic
Schematic Diagram Schema HO Train Model Lighthouse Flasher
Two transistor siren
Odd-ball PI circuit identification request and headroom question
Telephone line based audio muting and light on circuit



Top