Simple Field Strength Meter


Posted on Dec 9, 2012

This Field Strength Meter is simple and also quite sensitive. It uses an ordinary digital voltmeter to measure RF signal strength up to a few hundred MHz. The multimeter should be set to the lowest dc volts range for maximum sensitivity. This is normally 200mV DC for most meters. The circuit works well at VHF (around 100MHz) and was quite pleased with the results. L1 was 7 turns on a quarter inch former with ferrite slug.


Simple Field Strength Meter
Click here to download the full size of the above Circuit.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Distribution Amplifier
2x60 Watt Stereo Audio Amplifier LM4780
mc2833 fm transmitter circuit design electronic project
serial communication on atmega3216
Three-State Continuity Tester
DIY 100mw TV Transmitter Printed Circuit Board (PCB)
Length 1 minute delay relay pull transistor circuit diagram
DW16M-630 type DC excitation switch control circuit
555 direct reading frequency meter schematic



Top