4 Channel DMX512 Driver


Posted on Jul 2, 2012

This project is a 4 channel DMX512 driver board. It features four power MOSFETs that can be configured to operate in PWM mode or as on/off outputs. The driver can be configured to use any four consecutive addresses across the full 512 channel address range. It can be used to drive LED arrays or low voltage lamps in PWM mode or operate relays in static mode.



One of the design goals for this project was to keep the external hardware required to a minimum. For this reason, most of the configuration is held in the PICs EEPROM. The only two hardware enabled options are Output active drive level and Config mode




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

14 Watt Audio Amplifier
Increased Feedback-Stabilized Amplifier
Single Meter Clocks
LSB Conversion of RT321 and RT320 HF Sets
How To Build A Simple Car Alarm And Immobilizer
Analog HF Antenna Analyser
A typical circuit for the LM4916 two-channel amplifier
2450MHz end-stage linear power amplifier configuration of the circuit diagram RF2126



Top