Function-generator


Posted on Jan 30, 2013

This generator will supply sine, triangular, and square waves from 2Hz to 20kHz. This complete test instrument can be plugged into a standard 110 Vac line for power. VoVT will be up to ±25 V (50 V pk-pk across loads as small as 10 0 (about 2.5 A maximum output current). Capacitor working voltages should be greater than 50 V de and all resistors should be 112 W, unless otherwise indicated.


Function-generator
Click here to download the full size of the above Circuit.

The interconnecting leads from the 741 pins 2 and 3 to their respective resistors should be kept short, less than 2 inches if possible; longer leads might result in oscillation. Full output swing is possible to about 5kHz; after that the output begins to taper off because of the slew rate of the 741, until at 20kHz the output swing will be about 20 V,p± 10 V. This problem can be remedied by simply using an op amp with a higher slew rate, such as the LF356.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

200mA/Hour 12V NiCAD Battery Charger
Atari punk console + Baby sequencer 4017 IC
Zener diode tester
stepper motor controller schematic
50MHz 10mW handy transceiver
UHF Antenna Amplifier Circuit
NiMH Charger For Up To Six Cells
An SCR Based Burglar Alarm
One way to prevent reverse polarity of the DC power supply circuit
Level one thyristor-controlled circuit sink type b
Single-phase motor energy consumption of the two brake circuits



Top