Triple Waveform Generator with 8038


Posted on Jun 17, 2012

The Tri-Waveform Generator can be used for a number of different uses. The one that I use it for is a signal generator to test circuits. The frequency range is 20 to 20khz. and can be adjusted by R1. The duty cycle or the time that the waveform is high and the time that the waveform is low can be adjusted by R4. The purpose of R2 and R3 are to clean up any distortion on the sine wave output. To do this you must hook up the sine wave output to and oscilloscope and adjust R2 & R3 to make the sine wave as accurate as possible.


Triple Waveform Generator with 8038
Click here to download the full size of the above Circuit.




Leave Comment

characters left:

New Circuits

.

 


Popular Circuits

Simple PC smartcard reader
100 Mhz converter
Low-battery-warnlng-disconnector
Bus / Register Tutorial
ir remote control home appliance
fog lamp sensor circuit
Electric Guitar Preamplifier
Build a Michelson Interferometer
555 IC Water Level Sensor/Detector Alarm
22kW and below hoist with Y- transfer power-saving circuit



Top