Electronic Circuits Schematics Projects




Voltage controls sine-wave frequency

Rating: 3.00/10 (15Votes cast)

Category: Oscillator Circuits / Sine wave
Views: 4453
Rank: 0

The circuit in Fig 1 generates a 50-Hz to 1-kHz sinusoidal waveform that exhibits lower than 60-dB THD. The input voltage controls the output frequency with the relationship 1 kHz/V. The output amplitude is invariant with frequency over the entire operating range. IC1 is a V/F converter with an input control range of 0 to 1V. You adjust R5 so that the output frequency equals 1 kHz with a 1V. visit page.

Related circuits

Twin-T oscillator

This circuit produces an extremely low distortion sine wave, in spite of the non- linear devices used for amplitude limiting (D1 and D2). The reason is first that distortion (harmonics) is fed to the minus input of the opamp with far less loss than to the plus input, severely attenuating them....



Variable-gain stage uses voltage-output DAC

A voltage-output DAC normally generates an output voltage that is a fraction of the input-reference voltage. In many designs, however, it is necessary to multiply the input voltage by a programmable gain, or, in other words, to create a variable-gain stage. You can easily implement a...



Sinewave Generator schematics

The two circuits below illustrate generating low frequency sinewaves by shifting the phase of the signal through an RC network so that oscillation occurs where the total phase shift is 360 degrees. The transistor circuit on the right produces a reasonable sinewave at the collector of the 3904...



Sine wave oscillator

The oscillator delivers a high-purity sinusoid with a stable frequency



Simple Sine-Wave Generator Circuit

A 555 timer operating in the astable mode generates the driving pulses and two 4518 dual BCD (binary coded decimal) counters provide the square waves. A TL081 op amp serves as an output buffer-amplifier, and potentiometers Rl and R2 are used in order to control the pulse`s frequency and...



Pure Sine-Wave Generator Circuit

A TTL counter, an 8-channel analog multiplexer, and a fourth-order low-pass filter can generate 10- to 25-kHz sine waves with a THD better than -80 dB. The circuit cascades the two second-order, continuous-time Sallen-Key filters within ICS to implement the fourth-order low-pass filter. To...



Voltage controls sine-wave frequency

The circuit in Fig 1 generates a 50-Hz to 1-kHz sinusoidal waveform that exhibits lower than 60-dB THD. The input voltage controls the output frequency with the relationship 1 kHz/V. The output amplitude is invariant with frequency over the entire operating range. IC1 is a V/F converter with an...



Amplitude-stable oscillator has low distortion, low cost

The multivibrator is a common circuit that consists of an amplifier with both positive and negative feedback (Figure 1a). When the output is positive, the positive input terminal equals ½V+, and the voltage at the negative input terminal changes toward V+. When this voltage exceeds ½V+, the...



Articles & Projects
high voltage sine wave The high-voltage sine wave inverter schematic variable frequency inverter design this design is ... DC / DC part SG3525 control to change the DC output by changing the duty cycle of the output voltage.

I've tried building diffrent kinds of sine wave oscillators that I found on the net that world pretty well but they all seem to do crazy things when i try to adjust the frequency by varying the resistors and the freq ranges are unsatisfying. .... pots) your circuit needs to produce a precise, acc...

I am trying to see how can i generate a high ac voltage (sinusoidal 2000v peak to peak) from a battery (say 3.7v) source. I need the ac to be as close as possible to a sine wave, and the frequency range is more or less audio: ...

high voltage sine wave The high-voltage sine wave inverter schematic variable frequency inverter design this design is shown in Figure 2. Input power phase 380V, after the three-phase bridge ... All power switches IGBT, power tube drive dedicated the IGBT driver control chip M57959L within the ch...

While there are not these two groups of time delay circuit, the Dead Time of the high frequency frequency wave is about 100ns, after connecting up H bridge, under the situation of voltage regulation, do well in the open loop.

The U1 is integrator circuit, the R1 and C1 is component that control the triangle wave rise and fall time. The rise time and fall time will affect the triangle wave frequency. The triangle to sine wave converter circuit, input voltage ...

Sinewave Oscillator Based on Operational Amplifier

Variable frequency sine wave drive using PIC to control speed of AC motor


Comments




 characters left

Captcha

captchaPlease input letters you see on the image.
Click on image to redraw.



Facebook Comments

Most searched
 
Accounts area
Username:
Password:
Forgot password? Register
Circuits