Electronic Circuits Schematics Projects




New Knight Rider LED Board

Rating: 5.00/10 (47Votes cast)

Category: Light Laser LED Circuits / Led circuits
This circuit is also crossed to: Square wave
Views: 2017
Rank: 0

The TL082 (Or a TL072 also is OK) Creates an Adjustable Sawtooth Generator. (It also has a Square wave Output, but it isn`t used here.) The Left and Right LED`s are Connected in Series and if this circuit is used on a 12 volt system, and if a person wanted to they could connect 2 LED`s for each LED Shown. Additionally I show the LED`s Mounted on the Circuit Board, But they can be wired OFF Board if So Desired. 1) There is a 1K Pot that adjust the Voltage input to the LM3914. 2) There is a 5K pot that adjust the Output voltage of the Sawtooth Oscillator. 3) There is a 250K Pot to set the Frequency as Desired. 4) Additionally there is a Connection point between Pin 9 of the LM3914. Joining these together to creates a Bar Display. 5) Substituting an LM3915 or an LM3916 will create a Non-Linear Effect in the Lights. visit page.

Related circuits

Multi-color LED driver

Have you ever wondered how many different colors can illuminate a LED? One, two or maybe three? Constructing this simple circuit, you will find it much more. The key component in this design is a dual LED. One such accessory includes two inside the 'slices' of different diode LED, that each of...



LED Flasher IV

This circuit will flash a string of LED's, typically 16, with direct connection to the mains and with a period adjustable between 1 and 4 seconds depending on the setting of the 22K/1W pot. Operation at 110V should also be possible but has not been tested. It can be used as a Christmas Tree...



AC MAINS LED indicator schematic

Often the need to control light switch on the instrument. If napájíme LED source of low DC voltage sufficient to classify a series of LED-resistor of appropriate resistance. Another situation occurs, if a small supply available, or to indicate when the voltage needed before the safety equipment...



60 seconds timer with LEDs

The circuit is a 0-60 second timer using timer 555 and two 4017 for LED driving.



Flashing Led Controller

The LED with integrated flasher is connected in series with the base-emitter junction of transistor Tl. Thus, the l



80x32 LED matrix display

I recently purchased 10 SLM1608 (SLM1606) LED matrix display units from Ebay (you might also contact the seller directly at op16@gmx.de). These are 16x16 LED matrix units with a green and a red LED per pixel allowing each pixel to be switched to either green, red, amber or off. The goal of this...



Single and Two Cell White LED Drivers

The operating voltage of white LEDs coupled with my emotional need for low cost for a given function, motivates me to make LED drivers suitable for battery operated lanterns that can run from a small number of cells. White and Ultraviolet LEDs available at the time of this writing, require higher...



WHITE LED NIGHT LIGHT

This simple circuit is designed to plug into a standard AC electrical outlet. It uses four super bright white light emitting diodes (LED) in conjunction with a capacitor coupled full wave rectifier circuit. The LEDs are mounted in a box and are angled slightly to bounce the light off of a nearby...



Knight Rider Circuit aka. LED Chaser

Simple Electronic Breadboard Circuit


Comments




 characters left

Captcha

captchaPlease input letters you see on the image.
Click on image to redraw.



Facebook Comments

Most searched
 
Accounts area
Username:
Password:
Forgot password? Register
Circuits