Electronic Circuits Schematics Projects




Emergency Pump Control with 555

Rating: 9.00/10 (100Votes cast)

Category: Sensors Detectors / Liquid Sensing Circuits
This circuit is also crossed to: Relay Circuits , 555 Timer Circuits
Views: 5286
Rank: 0

A simple Sump Pump Control Circuit using NE555. visit page.
Emergency Pump Control with 555



Related circuits

Liquid level Alert

This circuit will emit an intermittent beep (or will flash a LED) when the water contained into a recipient has reached the desired level. It should be mounted on top of the recipient (e.g. a plastic tank) by means of two crocodile clips, acting also as probes. If a deeper sensing level is...



Liquid level detector

When liquid level reaches both probes, alarm is turned on



Water-Level Measurement Circuit

Using a capacitor sensor to detect a water level is a simple method of sensing. This circuit uses C5, which



Simple Flood Alarm Circuit

A common collector amplifier drives a 2N3904 switch to sound alarm BZ1. The wire leads to water sensor or sump pit, level switch, etc.



Water level alarm

This circuit not only indicates the amount of water present in the overhead tank but also gives an alarm when the tank is full. The circuit uses the widely available CD4066, bilateral switch CMOS IC to indicate the water level through LEDs. When the water is empty the wires in the tank are open...



WATER SEEPAGE ALARM

This simple circuit sounds a beeper when its electrodes detect water. It is powered by a single 1.5v N cell. A small 1.5v button battery will also work.



Latching Water Sensor

A balanced Wheatstone bridge controls a JK flip-flop that uses an op amp as an interface. This in turn drives a relay



Water level alarm

The circuit draws so little current that the shelf-line of the battery is the limiting factor. The only current drawn is the leakage of the transistor. The circuit is shown in the form of a water level alarm but by using different forms of probe can act as a rain alarm or shorting alarm; anything...



Articles & Projects
The series of automatic water pump controller is designed with 2 inputs NOR by 4 pieces and relay that is activated by the transistor. Automatic water pump circuit requires +12 VDC voltage source and can be used to control ...

Specifically, the licensee failed to ensure that fire damage to cables associated with the opposite unit's service water (SW) pumps, located in each unit's emergency switchgear (ESWGR) room, would not prevent operation of ... The licensee had previously entered this issue in the NAPS corrective a...

SINGLE STAGE HEAT PUMPS LOW VOLTAGE CONTROL CIRCUIT WIRING MODELS W**H W**H*D S**H S**H*D T**H T**H*D Manual : 2100-516G Supersedes: 2100-516F Emergency Heat Energize B, W2, E, G Dehumidification Energize ...

By means of a Relay, employed to drive a water pump, this circuit provides automatic level control of a water reservoir or well. The shorter ... LED Emergency Light Circuit With Battery Over Charge Protection. The following ...

... emergency generation, automated switching, inverters, lighting control systems, pump control systems and; Performs calibration on electrical and electronic systems and equipment; Designs and install special circuits, relay ...

Pump Controller For Solar Hot Water System. This circuit optimises the operation of a solar hot water system. When the water in the solar collector is hotter than the storage tank, the pump runs. The circuit comprises two ...

Chevy ABS and Brake Dash Light fix

ABS Brake Control Module Replacement


Comments




 characters left

Captcha

captchaPlease input letters you see on the image.
Click on image to redraw.



Facebook Comments

Most searched
 
Accounts area
Username:
Password:
Forgot password? Register
Circuits