Electronic Circuits Schematics Projects




IR Remote Control Extender Circuit (Mark 3)

Rating: 1.00/10 (96Votes cast)

Category: Other Circuits / 555 Timer Circuits
Views: 5251
Rank: 0

IR appliances use pulses (control signals) sent over a modulated IR carrier wave. The carrier wave may be modulated at various frequencies, 36-38KHz being the most popular.Some Satellite receivers use even higher frequencies than this. The IR1 remote module receives an infra red signal and separates control pulses from the modulation. To re-transmit, a 555 timer is configured as an astable oscillator. visit page.

Related circuits

Divide-multiply-with-only-one-trim

This relatively simple, inexpensive circuit requiring one trimming operation can multiply or divide with a consistentaccuracy of greater than 1 part in 1,000. An inexpensive CMOS version of standard 555 timer chip T, in conjunction with low-drift LMll error amplifier A3, an inexpensive analog...



555 Astable oscillator

This free-running multivibrator uses an external current sink to discharge the timing capacitor, C. Therefore, interval ^ may easily be 1000 the pulse duration, t1( which defines a positive output. Capacitor voltage, V^, is a negative going ramp with exponential rise during the pulse output...



Bootstrapped Timer

This circuit demonstrates how to use bootstrapping to seriously boost the output power of the timer. The LC555 can only put out about 50mA as it is. This circuit can put out at least 200mA and goes to the rail as well.



555 LED flasher II

The 555 circuit below is a flashing bicycle light powered with three C or D cells (4.5 volts). The two flashlight lamps will alternately flash at a approximate 1.5 second cycle rate. Using a 4.7K resistor for R1 and a 100K resistor for R2 and a 4.7uF capacitor, the time intervals for the two...



Colour Shifting LED`s

These circuits provide a means of altering the YELLOW output of RED / GREEN type two colour light emitting diodes. These circuits use the LM555 timer chip.



Integrator multiplies 555 delay

Long delay times can be derived from a 555 timer with reasonably sized capacitors if an integrator circuit is used.



Door-Chime Schematic

This is a circuit that could be used as a doorbell system like those that most homes have. From what I can tell, pressing the switch triggers the IC to oscillate and send electricity through the transistors to power the speaker. The IC type is not listed, but I am guessing that it is a 555 Timer.



9V Door Bell Chime Project

Build Your Own Door Bell Chime using 555 timer integrated circuit, a speaker, 5 resistors, 4 electrolytic capacitors, 1 ceramic capacitor, 3 diodes, 1 pushbutton switch and 9 V battery as power supply.



HDMI + IR / Digital Optical Audio (Bi-directional) over Cat Extender (Octava)

Impact Acoustics IR Repeater


Comments




 characters left

Captcha

captchaPlease input letters you see on the image.
Click on image to redraw.



Facebook Comments

Most searched
 
Accounts area
Username:
Password:
Forgot password? Register
Circuits