Electronic Circuits Schematics Projects




VOLTAGE-BASED CONTROLLER FOR SWITCHES

Rating: 3.00/10 (19Votes cast)

Category: Other Circuits / Switching Circuits
Views: 890
Rank: 0

Heres a simple circuit for controlling four switches from a distance through just a pair of wires.In the circuit, the inverting inputs (pin 2) of operational amplifiers IC1 through IC4 are set to refrence voltages of +12V, +9V, +6V, and +3V, respectively, through a chain of four 1k resistors (R1 through R4). visit page.

In the circuit, the inverting inputs (pin 2) of operational amplifiers IC1 through IC4 are set to refrence voltages of +12V, +9V, +6V, and +3V, respectively, through a chain of four 1k resistors (R1 through R4). http://www.electronicsforu.com/EFYLinux/circuit/july2003/cir5-voltage.pdf

Related circuits

Microphone-Controlled Voice-Activated Switch

An electret microphone feeds a bandpass filter circuit (IC1A), then feeds a comparator, which



7805 Turn-On Circuit Circuit

A logic level can control a 7805 regulator with this circuit. Q2 is a series switcliing transistor controlled by Ql.



Inexpensive Vhf/Uhf Diode Rf Switch

This circuit uses low-cost IN4148 diodes and exhibits about 1.5 dB insertion loss from 10 to 1000 MHz w



CMOS Toggle Flip Flop Switch

The circuit below uses a CMOS dual D flip flop (CD4013) to toggle a relay or other load with a momentary push button. Several push buttons can be wired in parallel to control the relay from multiple locations. A high level from the push button is coupled to the set line through a small (0.1uF)...



Switch Debouncer

Using a 7473 JK flip-flop U1A connected as a monostable to drive U1B, as a switch debouncer. The circuit is self-clearing



AC triggered switch

An AC triggered switch for low frequency signals. This is a basic ac voltage operated switch made from discrete components. Both Q1 and Q2 work as common emitter amplifiers, but the biasing of Q1 is arranged by R3 and R4 so that about 0.5V is applied to its base; so with no input signal both...



Photoelectric switch

Synchronous switching is turning on only at the instant the ac supply voltage passes through zero, and turning off only when current passes through zero. This circuit provides this function in response to either a mechanical switch or a variable resistance such as a cadmium-sulfide photocell....



Optical toggle switch with 4027

Using dual flip-flop IC CD4027 employ a 555 based monostable circuit to supply input clock pulses. The circuit described here obviates this requirement. One of the two flip-flops within IC CD4027 itself acts as square wave shaper.



Opamp fundamentals part 2, voltage controlled switch with hysteresis

741 voltage controlled switch with sharp acting relay at its output


Comments




 characters left

Captcha

captchaPlease input letters you see on the image.
Click on image to redraw.



Facebook Comments

Most searched
 
Accounts area
Username:
Password:
Forgot password? Register
Circuits