Voltage window switch

Microcontroller multiplexes DIP switches

At times, a µC must read a large number of DIP switches, such as for system identification, bus-address setup, manual configuration, or other purposes. However, the available number of I/O lines is sometimes not enough to assign a switch to each one. You can use multiplexer ICs to share one I/O...

Scalable latch requires no capacitors or clock

Circuits that latch one-of-N switches usually use a digital approach. Such circuits are often useful in human-interface situations, such as audio-mixing consoles, video-feed selection, or current-loop-control redundancy systems. In high-precision analog systems, such as high-fidelity audio or...

Touch Switch circuit

A touch switch is a switch that is turned on and off by touching a wire contact, instead of flicking a lever like a regular switch. Touch switches have no mechanical parts to wear out, so they last a lot longer than regular switches. Touch switches can be used in places where regular switches...

PC mains switch

This project couldn't be any simpler if it tried. Using the PC's internal 12V supply to operate a relay, it is 100% reliable. If the PC is on, the peripherals are on and vice versa - it can't be otherwise (unless the relay fails). Other solutions have been suggested in magazines and the like,...

Switch Debouncing

This circuit will remove the transient spikes and contact bounces from a non-latching push button switch. Using a 555 timer as a monostable circuit, it is easy to build a good switch debouncer circuit. There are many circuits for SPDT debouncing, but not many for a normally open, push-to-make...

Electronic Switch ON-OFF

Here we have three choices, with which we can make electronic switches that use our touch or pressing (push button). We thus exploit the very big resistance of entry, that present the gates CMOS. In the fig.1 we have two gates NAND or NOR (IC1), connected as R-S flip-flop. Just as we press the...

Piezoelectric Vibration Sensor Activates Switch

An inexpensive piezoelectric wafer is used to detect vibration and when the vibration is sufficient a switch is activated.

1 button ON / OFF Switch with 555

This project describes how to build a "soft touch" switch. By "soft touch" we mean that you have to push once to set device ON and push again to set device OFF. This kind of switch works by latching a relay to ON state with push of a button and with another push latch is released. It is working...